Park Tool Tw-6.2 not clicking with out tightening?
I just replaced by bottom bracket for the first time and I wanted to make sure I was careful with the torque value, so I torqued the cups to 35nm and then reset the torque wrench to 40nm and did it again. This time though, the wrench clicked but the cups didn't move. Is this an issue or is this normal. The BB is a shimano BB52 and the wrench is a parktool Park Tool Tw-6.2. The wrench is brand new, I finally broke down and got a nice wrench and I just want to make sure if this is normal. Should I have just set the torque value to 40nm? Should I loosen the BB cups and retighten?