Originally Posted by
Rolla
You *should* be fine, but you'll know pretty early in the process if not; the shallowness of the channel won't consume as much tape width.
thanks - i was.
just set them up tubelss. For future reference here is what i did:
- 1 Layer of 23 mm Schwalbe tubeless rim tape, overlapped 2 spoke holes before and after the valve stem.
- Random tubless valve - > fun fact, due to the shallowness of the rim, i wasn't actually able to properly screw down the valve with the O-ring and locknut from the other side since there wasn't enough thread.
- Mounted Panaracer Gravelking 32mm Slicks and pumped it up with a compressor to see if it would actually hold air w/o sealent (FYI, it didnt really)
- 40 to 60 mL Stan's no tubes Tyre sealant. I put more in the rear tyre (60mL+) since i had no engagement with the threads and the valve stem
- Hooked up the compressor and pumped it up to 5 bars
- spun the wheels for a bit to distribute the sealant.
So far, they hold (and i presume they will). Gonna give them a testride later today.
Thanks you lot