View Single Post
Old 07-06-06, 06:00 PM
  #9  
thomson
Senior Member
 
thomson's Avatar
 
Join Date: Dec 2003
Posts: 3,333
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Quoted: 0 Post(s)
Likes: 0
Liked 0 Times in 0 Posts
The solution javaman describes is if you attempt to shift to a smaller cog and it dosn't shift or is delayed.

If your problem is that it shifts to smaller gears all on its own, the barends may not be holding the cable tension. There are big screw heads on the side that need to be tightened.
thomson is offline