Louis-Garneau TT Helmet Visor Installation Question
#1
Senior Member
Thread Starter
Join Date: Apr 2006
Location: Denver, CO
Posts: 1,960
Bikes: Cannondale R700 (2005)
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Quoted: 0 Post(s)
Likes: 0
Liked 0 Times
in
0 Posts
Louis-Garneau TT Helmet Visor Installation Question
So I purchased a Louis-Garneau Chrono-Leggera helmet, and then purchased the add-on visor for the helmet.
However - when I put the visor / windscreen on the outside (i.e. - rather than slide the windscreen in-between the helmet cover and the Styrofoam), there is a gap between the helmet and visor on the front.
When I try to slide it in between the helmet cover and Styrofoam, it will not fit.
I just want to check that it should go on the outside, and was hoping that this gap is normal (does not seem very aero, but then again, it is more aero than just sunglasses.
However - when I put the visor / windscreen on the outside (i.e. - rather than slide the windscreen in-between the helmet cover and the Styrofoam), there is a gap between the helmet and visor on the front.
When I try to slide it in between the helmet cover and Styrofoam, it will not fit.
I just want to check that it should go on the outside, and was hoping that this gap is normal (does not seem very aero, but then again, it is more aero than just sunglasses.
#2
Senior Member
Join Date: Nov 2008
Location: TX
Posts: 2,620
Bikes: Orbea Orca Trek 5500 Trek Equinox
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Quoted: 1 Post(s)
Likes: 0
Liked 0 Times
in
0 Posts
I have an LG Rocket and it goes on the outside. But I shoved it between the styrofoam and the shell because I think it looks better. Not sure if that helps you, sorry.
Thread
Thread Starter
Forum
Replies
Last Post
SpongeDad
"The 33"-Road Bike Racing
10
06-27-10 12:48 PM