Old 12-11-06, 12:26 PM
  #2  
TallRider
Senior Member
 
TallRider's Avatar
 
Join Date: Oct 2005
Location: Fresno, CA
Posts: 4,433
Mentioned: 5 Post(s)
Tagged: 0 Thread(s)
Quoted: 115 Post(s)
Likes: 0
Liked 1 Time in 1 Post
Do you mean that the diameter of the rear axle is too large to fit in the dropouts?
Or, that the spacing of the locknuts on the rear wheel is too wide to fit between the rear dropouts without stretching. It sounds like the latter, but you certainly didn't write your post in such a way as to make sure we know what you're talking about.

Most track frames are spaced 120mm between the inner sides of the rear dropouts (and yes, I know that they're not technically dropouts on track bikes, but that's the standard term for the place where the rear wheel's axle slides into, so I use it in reference to track bikes too).
Some track frames designed for Japanese Keirin racing have 110mm rear spacing.
If the difference is just thickness of paint, you're not dealing with a 10mm difference. Here's what you can do:
* stretch the rear dropouts slightly apart when you're putting the wheel in. This is completely fine if it's still, and basically fine with aluminum if it's 1-2mm.
* remove a spacer or two from the hub's axle
TallRider is offline