Old 09-07-08, 05:01 PM
  #1  
kuan
Twincities MN
 
kuan's Avatar
 
Join Date: May 2005
Location: Salsa, Cannondale, Surly.
Posts: 2,528
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Quoted: 0 Post(s)
Likes: 0
Liked 0 Times in 0 Posts
Picture of my Fenix light rack mount setup

Figured out a great way to mount my Fenix lights. This is perfect if you have lots of space on your front rack.

I found some foam "tubes" at a local surplus store. Then I slit the bottoms so they would fit around the bars. Then I built up the rear by wrapping a couple pieces of old tire tube around one of the beams so the lights would be angled slightly down. Then I used blue electrical tape to tape them down. Blue tape works best. They are secured by two O-rings per flashlight, with an additional large O-ring for redundancy because yes, I know, the Space Shuttle blew up because of an O-ring failure. They are still adjustable by adding shims if you need to. Popsicle stick or something, little twig maybe, works fine.



__________________
www.marrow.org
kuan is offline