View Single Post
Old 01-31-09, 11:18 PM
Chuckie J.
Senior Member
Chuckie J.'s Avatar
Join Date: Nov 2003
Location: North Carolina, USA
Posts: 297

Bikes: Too many... but I'm down to 8 :)

Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Quoted: 3 Post(s)
Liked 0 Times in 0 Posts
Originally Posted by Diggidy_Dylan View Post
The rear end of the BD is identical to the Xtracycle Freerad.
Here is a link to a pic of footsies on a BD. The velcro bit I'm thinking of atatches to the part that sticks out a little. I think it's near the inner red stripe near the back.

Here is another pic. You can barely see the velcro on the left one.

Lastly, Xtracycle has gone open source. While your footsies may be outdated, there's always their schematics you can use to determine proper drilling. Here's the link.

Good luck. Hope this helps.
Thank you, much. I will most likely re-drill.
Chuckie J. is offline