Press-fit Road Bike BB in an MTB?
#1
Senior Member
Thread Starter
Join Date: May 2001
Location: Sunny so. cal.
Posts: 904
Mentioned: 1 Post(s)
Tagged: 0 Thread(s)
Quoted: 136 Post(s)
Liked 57 Times
in
31 Posts
Press-fit Road Bike BB in an MTB?
Someone installed one on my mtb. That's what I found when I removed the old one for a repair. What this means is that the spacer didn't reach across to seal around the spindle where it enter though the bearing. It actually had vibrated loose from the one side that held it during assembly so that it was just floating loose on the crank spindle. Besides not sealing as well, does not reaching across also lesson support between the two bearing? Anyway, I did it right with a 92mm wide one.
#2
Senior Member
Join Date: Feb 2014
Location: Southern Ontario
Posts: 1,883
Mentioned: 5 Post(s)
Tagged: 0 Thread(s)
Quoted: 263 Post(s)
Likes: 0
Liked 9 Times
in
8 Posts
The Shimano instructions say that if you have a sealed bottom bracket shell you can leave the sleeve off. It's just to protect from crap coming down the seat tube and chain stays.
Thread
Thread Starter
Forum
Replies
Last Post
Cacti Dodger
Bicycle Mechanics
0
07-10-10 11:48 AM