Hedset maintenance period
 

I was just wondering:

In the case of moderate riding in a dry and clean environment, is it necessary to disassemble and execute maintenance work on headset at certain periods or km of riding?
I am asking because headset maintenance works for a bike with hydraulic disk brakes with internal routing and integrated handlebars is a nightmare: you have to disassemble the hoses, then cut their end at the brake caliper and use new “stealth-a-majig” olives and barbs for re-assembling. It is a long and expensive process; furthermore, if you do it 2-3 times, the hoses become too short and you must change them completely – another complication…

Title correction - "Headset..." :)

your headset is, almost assuredly, a sealed (cartridge) bearing type, and no set maint. schedule exists for them... if it begins to get rough, you replace the bearings, and possibly the entire headset, as needed.

Water makes a huge difference. Avoid water.

You may be able to gain sufficient access to inject fresh grease into the bearings, without completely removing/disconnecting anything. That could be enough to keep the headset running smoothly until you really need to decapitate the beast.

A mudguard can block most of the gritty water the front tyre flings at the crown race - even those little pieces of flat plastic that you zip-tie in place. Lizard Skins headset covers too.

If it gives you issue, then you know it's time to service them. If you do preventive maintenance, you are really just wasting your money on something that really doesn't cost much to fix if it were to go bad and require all the pieces parts to be replaced. -- IMO of course.


I only had to re-lube one of my very old vintage bikes with loose balls in the headset. And I think I only did that because for some reason I took the fork out.

I recommend these especially for the lower headset bearing.

Your headset is very likely use modern cartridge sealed bearings which are designed to operate for thousands of hours at hundreds to thousands of RPMs. A headset turns 1/2 a turn (at most) a few times an hour. That’s a very low duty cycle and doesn’t require any kind of maintenance for years in all probability. Even then, the bearings are meant to be replaced, not serviced in most cases.

In other words, leave them alone and don’t worry about it…even if you are riding in water 100% of the time.

BITD, a section of old inner tube stretched over the lower stack worked well to exclude water penetration.

Yes! I've done this many times. :thumb:

EDIT: The Lizard Skins looks better on the bike, though. :foo:
https://cimg6.ibsrv.net/gimg/bikefor...de106411ba.jpg