Front Mech and Crank Question
#1
Senior Member
Thread Starter
Join Date: Nov 2005
Posts: 289
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Quoted: 0 Post(s)
Likes: 0
Liked 0 Times
in
0 Posts
Front Mech and Crank Question
The XT front mech I just installed doesn't travel far enough over the big chain ring. I have taken the L screw out and still it doesn't. I have pulled the wire tight by hand to check this.
I have also just installed a 2006 Xt hollowtech II crank set - I have a 63mm BB shell and I I have put one spacer on the right (chain ring) side of the BB - this is the only thing that I think must be the problem with the front mech not able to move far enough out over the large ring.
So my questions - 1) any idea's on the front mech problem ? 2) cud it be the spacer on the BB that is the problem ? 3) How do I know if I need that spacer there or not ?
Thanks !!
I have also just installed a 2006 Xt hollowtech II crank set - I have a 63mm BB shell and I I have put one spacer on the right (chain ring) side of the BB - this is the only thing that I think must be the problem with the front mech not able to move far enough out over the large ring.
So my questions - 1) any idea's on the front mech problem ? 2) cud it be the spacer on the BB that is the problem ? 3) How do I know if I need that spacer there or not ?
Thanks !!
#2
Senior Member
Join Date: Feb 2005
Location: Oklahoma
Posts: 9,438
Bikes: Trek 5500, Colnago C-50
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Quoted: 4 Post(s)
Likes: 0
Liked 7 Times
in
6 Posts
When attaching the shift cable to the front derailleur the shifter must be in the smallest chainring position with all of the cable released from the shifter.
Al
Al
#3
Senior Member
Thread Starter
Join Date: Nov 2005
Posts: 289
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Quoted: 0 Post(s)
Likes: 0
Liked 0 Times
in
0 Posts
Pretty sure it was - I normally make sure I do that... I do not the think the cable is too tight - but I will release it and check.
Anyone know if I definitely need the spacer on the BB ?
Anyone know if I definitely need the spacer on the BB ?