Front Derailler Problem? or is it just me.
09-26-06, 09:26 AM
#1
Member
Thread Starter
Join Date: Apr 2005
Location: Spencer, WI
Posts: 36
Bikes: Surly Crosscheck
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Quoted: 0 Post(s)
Likes: 0
Liked 0 Times
in
0 Posts
Front Derailler Problem? or is it just me.
Hi,
I just bought a Tiagra front derailler off of ebay for my Surly Crosscheck. I have old shimano 105 7-speed components mounted with a double in the front. My problem is I can't seem to get enough "lateral travel" out of my front derailler to get the outer plate outside of my large chain ring. The adjustment screw is bottomed out and I have another .5 cm to go just to be flush. Is this a bottom bracket/crank problem? Is it something in the way I hung the derailler? Any help is greatly appreciated. Thanks.
I just bought a Tiagra front derailler off of ebay for my Surly Crosscheck. I have old shimano 105 7-speed components mounted with a double in the front. My problem is I can't seem to get enough "lateral travel" out of my front derailler to get the outer plate outside of my large chain ring. The adjustment screw is bottomed out and I have another .5 cm to go just to be flush. Is this a bottom bracket/crank problem? Is it something in the way I hung the derailler? Any help is greatly appreciated. Thanks.
09-26-06, 09:34 AM
#2
Senior Member
Join Date: Feb 2005
Location: Oklahoma
Posts: 9,438
Bikes: Trek 5500, Colnago C-50
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Quoted: 4 Post(s)
Likes: 0
Liked 7 Times
in
6 Posts
Was the shifter in the lowest position when the cable was attached? If it is STI, with the cable detached, flip the small shift lever several times while pulling the free end of the cable. Then re-attach and try again.
Also check that the "H" limit screw is backed out enough.
Al
Also check that the "H" limit screw is backed out enough.
Al
09-26-06, 09:35 AM
#3
Member
Thread Starter
Join Date: Apr 2005
Location: Spencer, WI
Posts: 36
Bikes: Surly Crosscheck
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Quoted: 0 Post(s)
Likes: 0
Liked 0 Times
in
0 Posts
To answer my own question, I think I just found it in another thread. I think my spindle is too long on the bottom bracket. It was salvaged from my last bike, and I think my chainline is actually messed up in the same direction. Sounds like I need to do a little investigating or go to the LBS. Sorry for the inconvenience of an unnecessary post!
