Hub smoothness
03-10-07, 09:32 AM
#1
R900Campagnolo
Thread Starter
Join Date: Jun 2005
Location: Brooklyn
Posts: 884
Bikes: track and road
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Quoted: 0 Post(s)
Likes: 0
Liked 0 Times
in
0 Posts
Hub smoothness
I got a new wheel (fulcrum zero) from the factory. When I spin the wheel there is a little click in the hub on every rotation and it spins for about 45 seconds (only).the bearings are adjustable.
Should I adjust the bearings?
Regrease them?
Ride them?
Should I adjust the bearings?
Regrease them?
Ride them?
03-10-07, 09:40 AM
#2
Bikaholic
Join Date: Dec 2006
Location: Western, Michigan
Posts: 1,461
Bikes: Trek Fuel 90, Giant OCR, Rans Screamer Tandem
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Quoted: 0 Post(s)
Likes: 0
Liked 0 Times
in
0 Posts
Don't count on the OEM to get it right. For perfection, do it yourself. Buy good products and check them over. Re-pac the bearings and look for flat spots on the bearings or in the race. On second thought, if this was bought locally, take it back for this inspection. If bought online, email cust service before proceeding. you don't want to void any warranty you may have.
03-11-07, 06:17 AM
#3
Senior Member
Join Date: Nov 2005
Location: Hobart
Posts: 126
Bikes: Schwinn, National, Tassie Cycle, Avanti, Standish
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Quoted: 0 Post(s)
Likes: 0
Liked 0 Times
in
0 Posts
If it is the rear hub, check the casette for looseness on the splines: I found a loose casette by tracing a 1click/revolution when the chain was off. Spinning for 45 seconds could be drag from lots of grease and good seals.
