Help with installing STI brifters on bar
#1
Junior Member
Thread Starter
Join Date: Jun 2007
Posts: 8
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Quoted: 0 Post(s)
Likes: 0
Liked 0 Times
in
0 Posts
Help with installing STI brifters on bar
Okay, so I'm an idiot--please be gentle. I have a set of 105 brifters and I can't seem to locate the bolt in the lever body that allows me to loosen/tighten the metal bands that clamp onto the bar. Can you give any guidance as to what I should be looking for, or even better, a picture?
#2
Boomer
Join Date: Nov 2003
Posts: 7,214
Bikes: Diamondback Clarity II frame homebuilt.
Mentioned: 106 Post(s)
Tagged: 0 Thread(s)
Quoted: 16098 Post(s)
Liked 1,457 Times
in
1,064 Posts
On the side of the brifter, just forward on the rubber good you will find a half (sort of) round groove. This is where you place the allen wrench as you push it in under the hood. Feel around for a while and you will seat into the bolt.
__________________
#3
Still can't climb
Join Date: Sep 2006
Location: Limey in Taiwan
Posts: 23,024
Mentioned: 25 Post(s)
Tagged: 0 Thread(s)
Quoted: 12 Post(s)
Likes: 0
Liked 6 Times
in
6 Posts
I just upgrade from downtube to 105 brifters last weekend. On the out side of each shifter there is a little dpression in the metal. Here you can stick a fingernail in and lift the hood (not peel back just lift). There is an allen head screw inside but you have to pull the rubber hoodout quite a bit to see it.
#4
Senior Member
Join Date: Jul 2007
Posts: 2,114
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Quoted: 0 Post(s)
Likes: 0
Liked 1 Time
in
1 Post
Shimano's Site
Shimano has pdf files of the installation instructions. The link above is for the 105 group, just find the brifters you have.
Shimano has pdf files of the installation instructions. The link above is for the 105 group, just find the brifters you have.