FD shift into 3rd gear like a MOFO.
#1
Senior Member
Thread Starter
Join Date: May 2008
Posts: 247
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Quoted: 0 Post(s)
Likes: 0
Liked 0 Times
in
0 Posts
FD shift into 3rd gear like a MOFO.
My bike is all put together and running good, but shifting the FD into the largest cog is a PITA. I tried adjusting it and while the low adjuster screw does something, the high adjuster screw doesnt do anything. Finally I adjusted to a point were it shifts into 1 and 2 effortlessly, 3 with a lot of effort, and without any contact. I'm not sure what to do without having full adjustment, should I get another FD?
#2
Insane Bicycle Mechanic
Join Date: Mar 2008
Location: other Vancouver
Posts: 9,838
Mentioned: 34 Post(s)
Tagged: 0 Thread(s)
Quoted: 805 Post(s)
Liked 706 Times
in
377 Posts
More info please. What kind of bike? What kind of shifter? What kind of derailleur? What kind of crank?
I've encountered what you're describing when there's a mismatch between the derailleur and the shifter. Without more details, it's impossible to know.
I've encountered what you're describing when there's a mismatch between the derailleur and the shifter. Without more details, it's impossible to know.
__________________
Jeff Wills
Comcast nuked my web page. It will return soon..
Jeff Wills
Comcast nuked my web page. It will return soon..
#3
Senior Member
Thread Starter
Join Date: May 2008
Posts: 247
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Quoted: 0 Post(s)
Likes: 0
Liked 0 Times
in
0 Posts
IT's a 93 Trek multitrack 720, FD is stock, crank is stock, shifter is a Shimano ST-EF50-7R 7sp Brake/Shift Lever set
#4
Senior Member
Join Date: Apr 2008
Posts: 93
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Quoted: 0 Post(s)
Likes: 0
Liked 0 Times
in
0 Posts
First try to manually shift through all three gears up front by pulling on the derailer cable by hand. Shift to lowest gear on your shifter, and then grab the cable where it's exposed and pull, if you can get into third that way, then you need to adjust the tension/indexing of the shifter cable. If you're having problems shifting into third by pulling the cable, then you need to adjust the derailer first (either it's misaligned, or the H limit screw needs backing off).