Topolino front wheel problem
#1
Senior Member
Thread Starter
Join Date: Jan 2005
Posts: 842
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Quoted: 1 Post(s)
Likes: 0
Liked 0 Times
in
0 Posts
Topolino front wheel problem
I have a set of Topolino's Revelation C-19. There is too much play in the front axle and makes an irritating noise under load. I took the axle apart, lubricated it and reassembled it but the excessive play remains. Do I need to replace the axle?
Thanks
Thanks
#2
Senior Member
I would contact Topolino directly, or the shop where you bought the wheel.
cdr
cdr
#3
Senior Member
Join Date: Aug 2005
Location: Pittsburgh, PA
Posts: 33,656
Bikes: '96 Litespeed Catalyst, '05 Litespeed Firenze, '06 Litespeed Tuscany, '20 Surly Midnight Special, All are 3x10. It is hilly around here!
Mentioned: 39 Post(s)
Tagged: 0 Thread(s)
Quoted: 2026 Post(s)
Likes: 0
Liked 1,096 Times
in
742 Posts
It's not the axle, its the bearings. I'm not familiar with the hubs on these wheels but if they are cup-and-cone bearings, they need to be adjusted. If they have cartridge bearings, the bearings need to be replaced.
#4
Senior Member
Join Date: Sep 2005
Location: Laramie Wyoming
Posts: 2,970
Bikes: Merlin Extralight Topolino Wheels Campy Record
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Quoted: 0 Post(s)
Likes: 0
Liked 0 Times
in
0 Posts
Cartridge. Not sure how old they are but Topo had a bunch of bad bearings a few years ago. They sent me a replacement set for free. Send them an email with the serial number from the wheel (on a sicker under the rim tape near the hole for the valve stem). Very easy to replace. My problem was with the rear wheel. The bearing went after about 15000 miles. Front wheel has 24,000 - no bearing problem. By the way neither wheel has had to be trued in that time. I love those wheels.
__________________