Jagwire cable
#1
just going for a ride...
Thread Starter
Join Date: Jan 2008
Location: Hillsboro, Oregon
Posts: 584
Bikes: LeMond Sarthe, OCR A1, OCR 2, Cypress DX
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Quoted: 2 Post(s)
Likes: 0
Liked 0 Times
in
0 Posts
Jagwire cable
I am about to re-cable my wifes bike. I purchased a Jagwire Hyper Cable Kit. The kit comes with a rubber boot that gets installed just before the RD. I have never seen a rubber boot on a bike. Does it work? Are there problems with them? There seems to be two parts to it but the instructions are not to clear.
Its step #7
pdf https://jagwireusa.com/images/uploads...lleur_2009.pdf
thanks....
Its step #7
pdf https://jagwireusa.com/images/uploads...lleur_2009.pdf
thanks....
#2
Senior Member
Join Date: Mar 2006
Posts: 349
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Quoted: 0 Post(s)
Likes: 0
Liked 0 Times
in
0 Posts
I suspect it is there to keep water out of that last bit of housing. I've had my derailleur cables freeze up before after a freezing rain. It kinda sucks. I'm reminded of the Bassworm I read about on Sheldon Brown's glossary.
https://www.sheldonbrown.com/gloss_ba-n.html
https://www.sheldonbrown.com/gloss_ba-n.html
#3
Senior Member
Join Date: Feb 2004
Location: St Peters, Missouri
Posts: 30,225
Bikes: Catrike 559 I own some others but they don't get ridden very much.
Mentioned: 16 Post(s)
Tagged: 0 Thread(s)
Quoted: 1572 Post(s)
Liked 643 Times
in
364 Posts
Since it came with the cable set I'd use it.
I think that it's particularly valuable if you have top tube cable routing. Bikes with top tube cable routing run the rear shift cable down the seat stay and the cable enters that last short piece of cable housing at a near vertical angle. Any water that gfets splashed onto the shift cable will run down the cable right into the cable housing and collect in the low spot.
I think that it's particularly valuable if you have top tube cable routing. Bikes with top tube cable routing run the rear shift cable down the seat stay and the cable enters that last short piece of cable housing at a near vertical angle. Any water that gfets splashed onto the shift cable will run down the cable right into the cable housing and collect in the low spot.