Shimano 105 SLR Caliper Issue-Spring Effect
#1
Junior Member
Thread Starter
Join Date: Jul 2009
Posts: 12
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Quoted: 0 Post(s)
Likes: 0
Liked 0 Times
in
0 Posts
Shimano 105 SLR Caliper Issue-Spring Effect
I've got the above mentioned group, but I am having trouble adjusting the calipers. On a brake pull, both sides clamp, but only 1 side will release back into position. What do I need to do? See Picture. Thanks.
https://www.velobase.com/ViewSingleCo...m=117&AbsPos=3
https://www.velobase.com/ViewSingleCo...m=117&AbsPos=3
#2
Junior Member
Thread Starter
Join Date: Jul 2009
Posts: 12
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Quoted: 0 Post(s)
Likes: 0
Liked 0 Times
in
0 Posts
I think I found the problem. On the back of the pull arms, where the spring attaches, I am missing a black spring anchor. So when I pull, the spring slides instead of pushing the pull arm back into position.
#3
Junior Member
Thread Starter
Join Date: Jul 2009
Posts: 12
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Quoted: 0 Post(s)
Likes: 0
Liked 0 Times
in
0 Posts
Nevermind...it might be part of the problem, but the rear does it too and it has both spring sleeves. It must be a calibration issue that I apparently cannot ration out. Is anybody a brake expert? I think I have a safety pivot brake set that is side pull. How do I adjust the spring so that both pads reposition after a pull?
#4
Junior Member
Thread Starter
Join Date: Jul 2009
Posts: 12
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Quoted: 0 Post(s)
Likes: 0
Liked 0 Times
in
0 Posts
Fixed It! I would like to thank the administrators of the forum for providing a space for me to think, using words, about the issue I was having. You have made me the Socrates of the modern road bike forums. Please feel free to check out my future posts as I am sure I will again be the only one "thinking." By the way this website provided valuable info for figuring out what I needed to do...I just had to answer the riddle to figure it out. https://www.parktool.com/repair/readhowto.asp?id=22
Last edited by AJNewBiker; 07-24-09 at 07:29 PM. Reason: Additions