Help with computer install
#1
Junior Member
Thread Starter
Join Date: Oct 2008
Posts: 13
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Quoted: 0 Post(s)
Likes: 0
Liked 0 Times
in
0 Posts
Help with computer install
Ok so i just installed a Trek incite 11i on my bike. I had read a few of the previous threads so i knew to make sure the right sensors were in the right places etc... However now that it's set up the speedometer works fine however the cadence sensor remains permanently at 0. Any suggestions on how i could fix this?
#2
You Know!? For Kids!
Sometimes the magnet on the crank arm is too far from the sensor on the chain stay. Rotate the sensor so it is as close as possible to the crank arm, and/or put a spacer behind the magnet to decrease the gap between the magnet and sensor.
__________________
Are you a registered member? Why not? Click here to register. It's free and only takes 27 seconds! Help out the forums, abide by our community guidelines.
Are you a registered member? Why not? Click here to register. It's free and only takes 27 seconds! Help out the forums, abide by our community guidelines.
#3
cab horn
Join Date: Jun 2004
Location: Toronto
Posts: 28,353
Bikes: 1987 Bianchi Campione
Mentioned: 1 Post(s)
Tagged: 0 Thread(s)
Quoted: 42 Post(s)
Likes: 0
Liked 26 Times
in
19 Posts
Ok so i just installed a Trek incite 11i on my bike. I had read a few of the previous threads so i knew to make sure the right sensors were in the right places etc... However now that it's set up the speedometer works fine however the cadence sensor remains permanently at 0. Any suggestions on how i could fix this?