Disk break compatible?
 

Hi everyone,

I tried to do a search for this and didn't see any threads. I am wonder how I can tell if my bike would be compatible with disk breaks. The bike is a CAADX and has holes near the hub, but nothing much higher up. Let me know if you want me to post some pictures.

THanks!
Casey

Brake

Pictures will be needed to find out if your bike is disc brake ready

No, the CAADX in stock form cannot accept either a front or a rear disc brake. However, you could add a front disc by swapping the front for a disc-brake compatible fork. I run a disc brake front/canti rear set up on my commuter (built on a cyclocross frame):

http://home.comcast.net/~joejackson9...02690small.JPG

Thank you everyone. Sorry, brake. I work to much and made a Freudian slip.

You're definitely working too much. Seeing your mother in her lingerie is a Freudian slip.

Ok - Jeff, you owe me a keyboard. Does anyone know how to get beer out of a keyboard?

Casey, You need to become a mean green shopping machine , and..
Buy another bike .. solution is +1 .. one already made with disc brakes.
It will be a cost savings over what you asked about.
given :

fietsbob... this is music to my ears :-). I am hoping that the more (most?) cross bikes for next year will come with disk brakes since they are now allowed in all tears of racing. I love my cross bike, it is a great all around bike, but I need something with a little more stopping power for everyday use. I guess the salsa vaya looks and feels pretty sweet but is a little sluggish. Do you think I should wait and see about next years models? They should be out pretty soon, don't you think?

I assume your bike has centre-pull cantilever brakes. Are you using the stock brake pads or have you switched to something better?

Another option is mini-V brakes, which have good stopping power and are easy to set up, but take away some of your clearance for fat tires and fenders.

I wanted to ask the same question about my Norco Bigfoot which was built/purchased with U-brakes in the early 2000's. I take it that the same answer applies to my bike - if it wasn't built for disc brakes, they can't be installed now.

On the rear, there is no easy and safe way to install a rear disc brake on a frame not already equipped with a disc mount. On the front, swapping your current fork for a disc fork is relatively easy though not necessarily cheap once you factor in a new front wheel and the disc brake setup as well. You can do this on almost any bike these days as disc forks are available in a wide range of geometries.

U brakes? Are you sure? U brakes havn't been used on mass produced mountain bikes since like 1990 or so, and you can't mount U-brakes on the posts intended for cantilever or V brakes.

Casey,
Currently several bikes already have 700c 35ish wheels and disc brakes as commuters .
putting mudguards and etc, says you are not riding this in any cross races,
,you just need the disc brakes and the tire clearance..
Trek Portland , and Redline Conquest classic, will get that package now..
[if warehouse has any left]

I beleive you mean V-Brakes http://www.bikepedia.com/quickbike/B...foot&Type=bike
At any rate. The cost to make such a change:
Brakes - $80 - $150
Wheels - $150 - $350
Cables - $15 - $25
Fork if needed $150 - $350

So even if your bike was disc brake compatible, this is at least a $250 - $300 decision without any labor assuming you ar capable. An 11 year old $500 bike makes this swap a poor choice from a value standpoint at best.

Yeah, sorry, V-brakes.

OK, yeah, so the same answer applies. Thanks guys