adjusting RD - fine by hand, can't rear largest cog when assembled
#1
Newbie
Thread Starter
Join Date: Dec 2009
Location: Palm Harbor, FL
Posts: 67
Bikes: 2018 Specialized Roubaix Sport and Ruby Sport
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Quoted: 2 Post(s)
Likes: 0
Liked 2 Times
in
2 Posts
adjusting RD - fine by hand, can't rear largest cog when assembled
Had to replace a hood on the shift handle, so I disconnecting a beutifully adjusted Shimano Dura-Ace RD. Upon reassembly, I can't get it to shift into the largest cog. If I pull the cable at the downtube by hand the RD moves to the right spot under the largest cog. When I try to tighten the cable the RD always relaxes down one gear. I tried the barrel adjuster but that didn't do it. Any advice?
#2
Senior Member
Join Date: Apr 2007
Location: Munising, Michigan, USA
Posts: 4,131
Bikes: Priority 600, Priority Continuum, Devinci Dexter
Mentioned: 14 Post(s)
Tagged: 0 Thread(s)
Quoted: 685 Post(s)
Likes: 0
Liked 55 Times
in
37 Posts
You should be able: 1) Set shifter for smallest cog (i.e., for the highest gear), 2) Pull slack from the cable, 3) Tighten the cable, 4) Use barrel adjuster to remove any further slack.
Are you doing the above?
Are you doing the above?
#3
Newbie
Thread Starter
Join Date: Dec 2009
Location: Palm Harbor, FL
Posts: 67
Bikes: 2018 Specialized Roubaix Sport and Ruby Sport
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Quoted: 2 Post(s)
Likes: 0
Liked 2 Times
in
2 Posts
well, I thought so and it just wasn't happening. Lunch, a deep breath and your post and it worked just like it should. Thanks.
Thread
Thread Starter
Forum
Replies
Last Post
loimpact
Bicycle Mechanics
8
11-28-14 11:00 PM
ElMono
Bicycle Mechanics
5
05-20-11 10:22 PM