Sugino AT triple chainrings
#1
Newbie
Thread Starter
Join Date: May 2011
Posts: 1
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Quoted: 0 Post(s)
Likes: 0
Liked 0 Times
in
0 Posts
Sugino AT triple chainrings
I have two questions regarding chainrings for an old Sugino AT triple crank I recently cleaned up for a new build. The rings are 50-45-24 for a half-step gearing setup.
First question: does the beveled edge on the chainring teeth face in or out? I've gotten a range of opinions on this (e.g., in/out/doesn't matter). Can someone tell me "for sure"?
Second questions: is the 24t granny ring too small to use with a 45t middle? I've read that a 20-tooth difference is the max shift you can reliably do with a front derailleur.
Thanks!
First question: does the beveled edge on the chainring teeth face in or out? I've gotten a range of opinions on this (e.g., in/out/doesn't matter). Can someone tell me "for sure"?
Second questions: is the 24t granny ring too small to use with a 45t middle? I've read that a 20-tooth difference is the max shift you can reliably do with a front derailleur.
Thanks!