How to fit a correct size front chainwheel?
 

Hi All,
I still like to change a front crank set FC-M101. This a simple, square hole, 48/38/28 tooths, 170mm. I search a lot of time to change it. It is not possible to get the same.
How can I know the if the size is OK what I think to buy. (See link)When I write "size" I mean the the horizontal distance from the bike, size of the bottom bracket. (I tried one but it was 5-6 more near to the bike what was to big and also the tooth wheel was not good) I think to buy this in the link in the ebay. Is there any document that shows the sizes (measurements) of the crank set and the bottom bracket?

http://www.ebay.ch/itm/ws/eBayISAPI....:WNARL:CH:1123
Thanks.
losi

Do you want to keep the same gearing of your original crankset/chainwheel? Same crank arm length? Square taper BBs and cranksets are older tech but not hard to find. Manufacturers like Shimano usually post parts specs on their website.

Hi commo_soulja,
Thanks. i have to change the old tooth wheel and I like to have the same 48/38/28. The
bottom bracket not have change it is still good but I need the the chain wheel in the sme position. Can be that need to change also the bottom bracket. But I not find any
advise on Shimano Internet site with what part can change what parts. Also not find any measurement of any part on their Internet site what make impossible to think about. For that I ask here experienced people what I can do to change this old and simple crank set.
losi

losi, I can't find the data you need to reply positively that the crankset you want to install will swap without any further changes. Going just by pictures I think that it will. If not your bike shop will have a bottom bracket to allow the new crankset's use.

Brad

Hi Brad,
Thanks a lot. Hope it will fit or fit with a new (other size) bottom bracket.
You know I come from electronic. There have crossreference number what other number can change what.
I miss it here. Even they not give the size.
Will try buy it.
losi

Hi All.
This is a report
Finally Changed the Front tooth chain wheel FC-M103 to FC-M311 original Shimano one.
The front tooh chan wheel now about 1-2 mm to left but this is even better and could set it.
Thanks for all.
losi

losi, Thanks for the feedback.

Brad