Need help to the head screw
 

Hi Everyone,

Last month I knocked the curb. I unscrewed the front head to make adjustment. I found the whole front set is so tight, even if I totally unscrewed everything. Anyway, when I wanted to retight the top screw as shown in photos, I found I could just not lock the thread!

I am not expert for bike but I would like to try myself before I send the bike to the shop. You suggestion would be appreciated.

Regards,

Jing


http://bikeforums.net/attachment.php...hmentid=247133http://bikeforums.net/attachment.php...hmentid=247134http://bikeforums.net/attachment.php...hmentid=247135

Well, first of all, just to adjust the position of the stem, on that type of headset -- threaded-- merely unscrewing the stem bolt as is shown in the picture will not loosen the stem. Once the bolt is loosened (but not fully removed), give the bolt a whack with a mallet (rubber to prevent damaging anything) to free the wedge that holds the stem tight inside the headtube (see gray colored wedge at bottom of quill in this photo). http://bikeforums.net/attachment.php...hmentid=247141

Once the wedge pops free, you should be able to adjust stem position. Once stem is where you want it, tighten bolt (act of tighten bolt draws wedge upward, creating tight fit inside head tube, which holds the stem in place). If you can't get the bolt to engage the wedge (i.e. it wont tighten as you indicate), you may have unscrewed too much so bolt is not longer threaded into the wedge. Pull quill out and make sure the bolt is engaging the wedge, then put stem back in and tighten it down.

Second, If what you are saying is that whole headset isn't moving freely, then you need to pull stem all the way out, loosen and remove headset lockring, and adjust the headset to allow bearings to move more freely. Could be, you need to take whole headset apart to clean a regrease the bearings is the top and bottom cups.

Read this for more help. http://www.parktool.com/blog/repair-...eadset-service

I think perhaps you uncrewed that bolt too much and the wedge dropped down the tube. Take the stem out and see if the wedge is still there. If not it fell inside the tube. If it is there, the threads may have become stripped and that's why it won't tighten.

When you get the bolt and wedge sorted out, don't forget to put a generous film of grease on the quill stem and wedge so that they do not become frozen into the steerer tube due to time and corrosion. It is also vitally important that the stem is not inserted too deeply into the steerer, to avoid wedging the stem in a tapered part of the steerer, where it can come loose unexpectedly. Read about it here: http://www.sheldonbrown.com/gloss_w.html#wedgebolt