cable housing stops or ferrules for 3-speed levers?
#1
Senior Member
Thread Starter
Join Date: Oct 2004
Location: NYC
Posts: 2,124
Bikes: All 70s and 80s, only steel.
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Quoted: 2 Post(s)
Likes: 0
Liked 2 Times
in
2 Posts
cable housing stops or ferrules for 3-speed levers?
What can I use for holding the cable housing against the lever bodies on some plain 3-speed levers? Any suggestions? I tried some old road drop lever tabs/stops/thingees and they're not optimal for hold the cable against the lever body.
#2
Senior Member
Join Date: Dec 2005
Posts: 17,155
Mentioned: 481 Post(s)
Tagged: 0 Thread(s)
Quoted: 3809 Post(s)
Liked 6,684 Times
in
2,609 Posts
Do you mean brake levers? Or gear triggers? If brakes, it depends on the lever. Weinmann/Dia Compe levers take the same stops as most drop-bar levers. Older steel Raleigh levers take on that has a fairly small diameter end to fit in the lever body. I think this one from Loosescrews would work.
Neal
Neal
#3
Senior Member
Thread Starter
Join Date: Oct 2004
Location: NYC
Posts: 2,124
Bikes: All 70s and 80s, only steel.
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Quoted: 2 Post(s)
Likes: 0
Liked 2 Times
in
2 Posts
Do you mean brake levers? Or gear triggers? If brakes, it depends on the lever. Weinmann/Dia Compe levers take the same stops as most drop-bar levers. Older steel Raleigh levers take on that has a fairly small diameter end to fit in the lever body. I think this one from Loosescrews would work.
Neal
Neal