I got lucky. Mine came from the factory with my initial carved into it.

http://i241.photobucket.com/albums/f...0photos507.jpg

And marsupials. Explains the family of possums in my water bottle.

Significantly, my '74 doesn't.

This is the best explanation yet.

Speed holes.

Doesn't have a "CC" cutout, or doesn't have a cutout at all?

I always though the bikes with cut-outs were like race cars. The BB got rebuilt or at least serviced after every race anyhow. Besides the cut-out contributes to the weight reduction efforts.

I have not read all the messages.
but the correct answer is: to lower weight of the frame. it is an area where you could shave off a chunk of steel, yet still have a good sturdy bottom bracket joining your tubes.

as for the bearings, you should have a plastic sleeve to encase the axle and the bearings.

no, these were not limited to road bikes. track bikes had them too.
no, they were not "to let grease drip out".

maybe, they could be for water drainage, but not likely (except for frames with entry points, like holes in top tube to lower weight, cable-routing holes, etc.)

yes, to lower weight
yes, on a road bike, you would have a nylon (plastic) sleeve (some were very specific, some had accordeon style ripples, some were adjustable (2 cylinders, oneslightly conical that presses into the other)


Now... if anyone knows who made frames with an octagram bottom bracket cutout, some guy on FB would like to know (that is what I came searching for when it landed me here)

What do I get for winning?

And as for the octagram BB cutout, you know we need a picture, for posterity's sake.

Many rodents' ribs are hinged at the spine. Pretty amazing what they can fit into.