Go Back  Bike Forums > Bike Forums > Cyclocross and Gravelbiking (Recreational)
Reload this Page >

Help with building my cross bike - tire question

Notices
Cyclocross and Gravelbiking (Recreational) This has to be the most physically intense sport ever invented. It's high speed bicycle racing on a short off road course or riding the off pavement rides on gravel like : "Unbound Gravel". We also have a dedicated Racing forum for the Cyclocross Hard Core Racers.

Help with building my cross bike - tire question

Old 04-23-05, 08:54 AM
  #1  
Junior Member
Thread Starter
 
Join Date: Oct 2004
Posts: 8
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Quoted: 0 Post(s)
Likes: 0
Liked 0 Times in 0 Posts
Help with building my cross bike - tire question

I am getting close to finishing building a cross bike for my wife. I bought a Planet X Kaffenback steel frame off ebay and am using a mix of new and used Shimano components to build it up. I knew there was not much clearance between the seat tube and rear wheel so I bought 700x30 tires for the bike (Michelin Jet) - but it still looks awfully close - see picture. Being a newbie to cyclocross, I assume this could be problematic, but I don't know for sure. My wife is mainly going to use this for rails to trails type riding, she doesn't see any racing in her future.

Any recommendations for different tires, or should I just see how these ones go?
trirod is offline  
Old 04-23-05, 09:54 AM
  #2  
I ride my bike
 
Revtor's Avatar
 
Join Date: May 2004
Posts: 421
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Quoted: 0 Post(s)
Likes: 0
Liked 1 Time in 1 Post
looks a little close to me, but for general light riding it shouldnt be a problem. Racing, with mud and stuff building up there may be issues but for railtrails and fitness it should be fine. You might cinsider putting some kind of thin adhesive on the back of the seattube, thin clear plastic or something to help prevent damage to the frame....

~S
Revtor is offline  
Old 04-26-05, 08:45 AM
  #3  
Full Member
 
Join Date: Dec 2003
Location: San Francisco East Bay
Posts: 247

Bikes: 2016 Tom Kellogg steel Spectrum all-road, '89 Eisentraut Rainbow Traut, '81 Marinoni Special, 2018 Ritchey Road Logic, 2006 Ritchey Breakaway Cross, 2009 custom Joe Wells alu Tsunami CX, '71 Favorit (Czech Rep) Special, 2012 Co-Motion Tandem

Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Quoted: 5 Post(s)
Liked 7 Times in 6 Posts
The Michelin Jet tires are labelled 30c but they are pretty big, more like 35c in reality. The PlanetX site says that model can use up to 32c tires- looks like youre at the limit with the Michelins. Which is too bad, and pretty stupid actually because clearly you can't fit a lot of common cross knobbies in there, which sucks if you really want to do any real cross riding or get into any mud. I'm no builder, but it looks like they need a design tweak- add another few mm's to the chainstays, or steepen the seat tube angle. Anyway, the clearance with the Jets is probably OK until you get into any mud- you'll want to protect the frame with something like electrical tape, or you can also use clear contact paper or something. The paint will wear off in that space pretty quickly. If she's really riding mostly on pavement, with a little dirt path riding, you might consider a 28c road tire- Continental gatorskin, Specialized Armadillo, Panaracer Pasella are three that come to mind, and there are others. A 28c tire pumped up to 90 psi will be fine for dirt paths, and faster than the Michelin Jets on pavement. What the heck were they thinking at Planet X???
ZenNMotion is offline  
Old 04-27-05, 01:21 AM
  #4  
Senior Member
 
stric's Avatar
 
Join Date: Jul 2004
Posts: 119
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Quoted: 0 Post(s)
Likes: 0
Liked 0 Times in 0 Posts
Boy this is really close. But it's hard to tell what the real problem is only from the picture. Are you sure the frame takes 700mm rims? Perhaps the frame is very small, but Iwould doubt that the frame maker would make such a flaw and leave so little room. It might sound cheap advice, but take it to a good bike shop and have them look at it. perhaps they can come up with some ideas. F
stric is offline  
Old 04-27-05, 08:24 AM
  #5  
Get the stick.
 
darkmother's Avatar
 
Join Date: Nov 2004
Location: Toronto, ON
Posts: 1,543

Bikes: 12 Y.O. Litespeed MTB, IRO Jamie Roy fixie, Custom Habanero Ti 'Cross, No name SS MTB, Old school lugged steel track bike (soon)

Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Quoted: 0 Post(s)
Likes: 0
Liked 1 Time in 1 Post
Michelin sizes their tires honestly. Their 28's are larger than most 32's. Try it out, and if it rubs, then use a smaller tire. My ritchey 32c's are way smaller than what you have on there.
darkmother is offline  
Old 04-27-05, 07:52 PM
  #6  
Junior Member
Thread Starter
 
Join Date: Oct 2004
Posts: 8
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Quoted: 0 Post(s)
Likes: 0
Liked 0 Times in 0 Posts
I actually swapped in my 32c Bontrager Jones CX tires from my Poprad and was pretty surprised to see I had significantly more clearance than with the Michelin 30c's. I guess the sizes can be taken with a pinch of salt. I guess we'll swap tires for the moment and see how the Bontragers work - otherwise I think 28c road tires will be fine since my wife has no interest in racing at this stage.
trirod is offline  
Old 05-02-05, 09:55 PM
  #7  
Junior Member
 
Join Date: May 2005
Posts: 3
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Quoted: 0 Post(s)
Likes: 0
Liked 0 Times in 0 Posts
Originally Posted by trirod
I am getting close to finishing building a cross bike for my wife. I bought a Planet X Kaffenback steel frame off ebay and am using a mix of new and used Shimano components to build it up. I knew there was not much clearance between the seat tube and rear wheel so I bought 700x30 tires for the bike (Michelin Jet) - but it still looks awfully close - see picture. Being a newbie to cyclocross, I assume this could be problematic, but I don't know for sure. My wife is mainly going to use this for rails to trails type riding, she doesn't see any racing in her future.

Any recommendations for different tires, or should I just see how these ones go?
Looks a bit tight... If you're interested I've got a frame mint Cannondale T700 for sale that would fit you nicely. I just posted it earlier. https://homepage.mac.com/tonyreidsma/...oAlbum164.html

Tony
tonyreidsma is offline  

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are Off
Pingbacks are Off
Refbacks are Off


Thread Tools
Search this Thread

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.