Originally Posted by unterhausen (Post 21252420)

I'm comparing the cost of the Velo Lumino to rc connectors, not supernova. I got the supernova connectors with my light. They are pretty elaborate and quite large for what they are.

Originally Posted by steelbikeguy (Post 21250492)

Originally Posted by steelbikeguy
for what it's worth, this is what I've been using with my first generation Schmidt dynamo for a very long time (18 years??)
I use some Amphenol pins and sockets. Nice reliable parts, available at Digi-key with p/n's #889-1233-ND and #889-1232-ND. No reason that any other quality pins and sockets wouldn't work too.

I solder mine, but there is a crimp tool made for them. The tool is rather pricey.... I'm guessing about $100 or more?... which really only makes sense if you are using these pins quite a lot.
I also use the soldering iron to shrink the heat-shrink tubing over the wire and connector junction.

Steve in Peoria

Originally Posted by freckles (Post 21252470)

the amphenol pins/sockets you referenced can be soldered in place?- they are listed as needing to be crimped? i like your set up alot and will try soldering them too unless i can borrow a crimper for it:thumb:

Originally Posted by steelbikeguy (Post 21252801)

I do solder mine. It's not a problem.

As far as crimping, it's unlikely that you'll the crimper any place that doesn't use these specific pins a lot. Using any other crimper will result in either over-crimping or under-crimping.

Steve in Peoria

Originally Posted by freckles (Post 21252455)

would you recommend the Velo Lumino banana connectors over the Supernova? the VL are smaller which is a plus.