Cycle computer ?
Hello all. I am new here and I have a weird question. I bought one of those cheap cycle computers and it says to mount the sensor 1mm to the magnet. Well the closest I can get is 2 cm . My question is, can I use a larger magnet and have it work at a greater distance than 1mm ? Thank you all !!!
|
it should be totally possible to do less than 2cm. in practice i find about 5mm plenty enough to activate the sensor. try to mount the sensor inside the fork with electrical tape to get it in nice and close.
|
Ususlly you can move it up or down the fork leg to get the required spacing.
|
agree with johnny0 and wmodavis...should be easy to get the correct spacing. kwh3rd if you have a special case do you think you could take a picture and post it? That may help us help you diagnose/solve the problem.
|
1mm is possible. Try the sensor on the right fork and the magnet on a left spoke, and adjust both while spinning the wheel until you get a signal.
|
All times are GMT -6. The time now is 05:59 PM. |
Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.