Pump for pump pegs
#1
Senior Member
Thread Starter
Join Date: Jul 2007
Location: Perth, Western Australia
Posts: 386
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Quoted: 3 Post(s)
Likes: 0
Liked 0 Times
in
0 Posts
Pump for pump pegs
Hi, I'm after a pump for some pegs spaced 11.5", so just over 29cm from tip to tip.
I have found a Zefal ATB, Lapize and 800 advertised as having a length of 300mm, would this be 300mm "fully compressed" or just "closed"?
If its 300mm fully compressed, I could probably squeeze it in, if its just closed, it probably wont stay in.
Anyone know of any other pumps which would fit?
Someone in C&V said there was a thread here about cutting a pump down to fit, but I cant find it. Anyone know?
Thanks.
I have found a Zefal ATB, Lapize and 800 advertised as having a length of 300mm, would this be 300mm "fully compressed" or just "closed"?
If its 300mm fully compressed, I could probably squeeze it in, if its just closed, it probably wont stay in.
Anyone know of any other pumps which would fit?
Someone in C&V said there was a thread here about cutting a pump down to fit, but I cant find it. Anyone know?
Thanks.
#2
Senior Member
Join Date: May 2005
Location: Albany, WA
Posts: 7,393
Mentioned: 16 Post(s)
Tagged: 0 Thread(s)
Quoted: 321 Post(s)
Likes: 0
Liked 7 Times
in
6 Posts
I cut a standard cheapo pump to fit my Raleigh 20's pegs. I cut the front end because the other end has a thread in it. I glued the front plug bit back in after separating it from the cut off bit.