Pump Leather
 

I have an old Schwinn approved floor pump made in Japan. The leather no longer seals. Can any one tell me how to recondition the seal? I tried greasing the seal with no success I think it's worn out and needs to be replaced. The pump bore is 32mm. What size leather should I use? I've searched online and can't find a 32mm one.. Thanks for your advice.

Occasionally you see vintage pump leathers on eBay, but the models and sizes make it fairly hit and miss.
You might look to see if there is a Tandy leather shop near you. Or any leather shop for that matter.
Take your old one off and take it in there. Find a proper thickness and size. I'd get an extra piece just in case.
You'll have to size it yourself with scissors or a hole punch. It needs to be a bit larger than 32mm. They kind of have a cupped shape. That's why I'd get a couple pieces, so if cut too small, try again. I'd probably start at 34mm.

Short of that. Saddle soap, Brooks proofide or 30w oil might bring it back. Depends on how hard it is.

32mm is 1.25 inches

​​​​​​https://merrillmfg.com/products/cup-leathers#

​​​​​​https://www.deanbennettsupply.com/pr...FT-LEATHER-CUP

I got a 19" Britiannialloy Grand Prix pump a few months back.
Local handyman / hardware shop had an ancient box full of "leather cup washers".
2 for £2, works perfectly.

(Belton & Slade, Wandsworth high street).