Go Back  Bike Forums > Bike Forums > General Cycling Discussion
Reload this Page >

XMart Bell Chains: OK in a pinch?

Search
Notices
General Cycling Discussion Have a cycling related question or comment that doesn't fit in one of the other specialty forums? Drop on in and post in here! When possible, please select the forum above that most fits your post!

XMart Bell Chains: OK in a pinch?

Thread Tools
 
Search this Thread
 
Old 12-06-07, 03:25 PM
  #1  
Senior Member
Thread Starter
 
zoeglassjd's Avatar
 
Join Date: Jan 2005
Posts: 331
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Quoted: 0 Post(s)
Likes: 0
Liked 0 Times in 0 Posts
XMart Bell Chains: OK in a pinch?

We are a car-light family and my wife is away with the vehicle this week. I got into a bit of a pinch in which I needed a new chain. I was not able to get to the bike shop, but able to get to a box store (not normally a shopper there). I picked up a bell chain with a bell "quick link" so I could commute today (and probably in the future).

I am wondering: do others use/have used the bell chain? Have you had any problems with them? Do you love em?

I am pretty certain I wouldn't put it on my roadie or mtb, but on my commuter where I do a 4 mile relaxed commute it seems ok.

Thanks for any feedback!
zoeglassjd is offline  
Old 12-06-07, 04:39 PM
  #2  
Senior Member
 
c_m_shooter's Avatar
 
Join Date: Sep 2006
Location: Paradise, TX
Posts: 2,087

Bikes: Soma Pescadero, Surly Pugsley, Salsa Fargo, Schwinn Klunker, Gravity SS 27.5, Monocog 29er

Mentioned: 1 Post(s)
Tagged: 0 Thread(s)
Quoted: 186 Post(s)
Liked 234 Times in 166 Posts
I used one on my single speed mountain bike for almost a year before I broke it. It didn't actually break, one of the links just came apart. I just pressed it back together and am still using it. Make sure if you use the master link that came with it that the opening of the clip faces the rear when it is on the top of the chain, or else it will get knocked off.
c_m_shooter is offline  
Old 12-06-07, 04:42 PM
  #3  
Cycle Dallas
 
MMACH 5's Avatar
 
Join Date: Jun 2005
Location: Land of Gar, TX
Posts: 3,777

Bikes: Dulcinea--2017 Kona Rove & a few others

Mentioned: 1 Post(s)
Tagged: 0 Thread(s)
Quoted: 197 Post(s)
Likes: 0
Liked 10 Times in 5 Posts
I put one on one of my bikes a while back. If you go that route, you HAVE to lube it regularly. I can be a little lax about that and this bugger showed rust fairly quickly.

The SRAM chains I use now are considerably more rust resistant.
MMACH 5 is offline  
Old 12-06-07, 04:46 PM
  #4  
Senior Member
Thread Starter
 
zoeglassjd's Avatar
 
Join Date: Jan 2005
Posts: 331
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Quoted: 0 Post(s)
Likes: 0
Liked 0 Times in 0 Posts
Originally Posted by c_m_shooter
Make sure if you use the master link that came with it that the opening of the clip faces the rear when it is on the top of the chain, or else it will get knocked off.
This is a good tip. I'll have to check to see if I did this. Will the additional torque on top pull it open? I actually realized I need to resize a bit, I may just take the quick link out when I do. I guess that's the scariest part. I generally lube in the winter on the commuter every other or every third day when in the slosh.

Shooter, if you used it on a SS mtb I think it can take my commuting stroll. Did yours have a quick link on it?

Thanks.
zoeglassjd is offline  
Old 12-06-07, 04:59 PM
  #5  
Healthy and active
 
twobikes's Avatar
 
Join Date: Mar 2007
Location: Caldwell, Idaho USA
Posts: 887

Bikes: mid-60's Dunelt 10-speed, Specialized Allez Sport Tripple, Trek 7.2 FX

Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Quoted: 1 Post(s)
Likes: 0
Liked 1 Time in 1 Post
I bought a Bell chain at Wal-Mart for my 10-speed road bike back in September. I have 427 flawless miles on it. The instructions that come with it tell about the correct orientation of the master link. It shifts well and runs very quietly. I have been lubricating it with new motor oil.
twobikes is offline  
Old 12-06-07, 06:15 PM
  #6  
Senior Member
 
Sci-Fi's Avatar
 
Join Date: Sep 2006
Posts: 1,329
Mentioned: 1 Post(s)
Tagged: 0 Thread(s)
Quoted: 16 Post(s)
Likes: 0
Liked 2 Times in 2 Posts
Bell Chains are ok...think somebody said KMC makes them. The chains they sell at OSH are decent and price competitive....the kids around my area love the gold colored chain for their MTN and SS bikes. OSH is where I pickup spare master links.
Sci-Fi is offline  
Old 12-06-07, 06:39 PM
  #7  
cab horn
 
Join Date: Jun 2004
Location: Toronto
Posts: 28,353

Bikes: 1987 Bianchi Campione

Mentioned: 1 Post(s)
Tagged: 0 Thread(s)
Quoted: 42 Post(s)
Likes: 0
Liked 26 Times in 19 Posts
They're just cheapo KMC chains that your LBS also sells.
operator is offline  
Old 12-06-07, 07:29 PM
  #8  
Conservative Hippie
 
Join Date: Mar 2005
Location: Wakulla Co. FL
Posts: 4,271
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Quoted: 1 Post(s)
Likes: 0
Liked 0 Times in 0 Posts
That's all I use on my Townie3, is two Bell chains linked together for the length. Works fine, even for heavy towing.

On my derailler equipped bikes I've gone to SRAM when the stock chain needs replacing.
CommuterRun is offline  
Old 12-06-07, 07:46 PM
  #9  
Membership Not Required
 
wahoonc's Avatar
 
Join Date: Jan 2005
Location: On the road-USA
Posts: 16,855

Bikes: Giant Excursion, Raleigh Sports, Raleigh R.S.W. Compact, Motobecane? and about 20 more! OMG

Mentioned: 5 Post(s)
Tagged: 0 Thread(s)
Quoted: 70 Post(s)
Likes: 0
Liked 15 Times in 14 Posts
I will Ditto the KMC I have a couple in the Bell packaging that say KMC on the side plates. I would think using them on a light use low miles bike is okay, but I don't think I would want to head off on a world tour on one.

Aaron
__________________
Webshots is bailing out, if you find any of my posts with corrupt picture files and want to see them corrected please let me know. :(

ISO: A late 1980's Giant Iguana MTB frameset (or complete bike) 23" Red with yellow graphics.

"Cycling should be a way of life, not a hobby.
RIDE, YOU FOOL, RIDE!"
_Nicodemus

"Steel: nearly a thousand years of metallurgical development
Aluminum: barely a hundred
Which one would you rather have under your butt at 30mph?"
_krazygluon
wahoonc is offline  
Old 12-06-07, 08:54 PM
  #10  
Senior Member
 
c_m_shooter's Avatar
 
Join Date: Sep 2006
Location: Paradise, TX
Posts: 2,087

Bikes: Soma Pescadero, Surly Pugsley, Salsa Fargo, Schwinn Klunker, Gravity SS 27.5, Monocog 29er

Mentioned: 1 Post(s)
Tagged: 0 Thread(s)
Quoted: 186 Post(s)
Liked 234 Times in 166 Posts
Originally Posted by c_m_shooter Make sure if you use the master link that came with it that the opening of the clip faces the rear when it is on the top of the chain, or else it will get knocked off.

This is a good tip. I'll have to check to see if I did this. Will the additional torque on top pull it open? I actually realized I need to resize a bit, I may just take the quick link out when I do. I guess that's the scariest part. I generally lube in the winter on the commuter every other or every third day when in the slosh.

Shooter, if you used it on a SS mtb I think it can take my commuting stroll. Did yours have a quick link on it?

Thanks.



All my motorcycle chains use the same sort of master link. With the direction that the chain is moving they will get knocked off if they are on wrong. I had the dealer install a new chain and sprockets on my Ducati Monster and they put the clip the wrong way. It was gone when I got home. I was lucky the chain didn't come off. I haven't let anyone but me work on any of my bikes since.
c_m_shooter is offline  
Old 12-06-07, 10:40 PM
  #11  
Senior Member
Thread Starter
 
zoeglassjd's Avatar
 
Join Date: Jan 2005
Posts: 331
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Quoted: 0 Post(s)
Likes: 0
Liked 0 Times in 0 Posts
Holy smokes. If you want a job done right...



don't go to the dealer apparently. Thanks for easing my mind everyone.
zoeglassjd is offline  
Old 12-09-07, 10:41 AM
  #12  
Perineal Pressurized
 
dobber's Avatar
 
Join Date: Oct 2003
Location: In Ebritated
Posts: 6,555
Mentioned: 0 Post(s)
Tagged: 1 Thread(s)
Quoted: 3 Post(s)
Likes: 0
Liked 2 Times in 2 Posts
They do indeed work well. I wouldn't do any extended trips on them without backup, but then again I wouldn't do that with any chain.
__________________
This is Africa, 1943. War spits out its violence overhead and the sandy graveyard swallows it up. Her name is King Nine, B-25, medium bomber, Twelfth Air Force. On a hot, still morning she took off from Tunisia to bomb the southern tip of Italy. An errant piece of flak tore a hole in a wing tank and, like a wounded bird, this is where she landed, not to return on this day, or any other day.
dobber is offline  
Old 12-09-07, 01:18 PM
  #13  
Really Old Senior Member
 
Bill Kapaun's Avatar
 
Join Date: Feb 2007
Location: Mid Willamette Valley, Orygun
Posts: 13,873

Bikes: 87 RockHopper,2008 Specialized Globe. Both upgraded to 9 speeds. 2019 Giant Explore E+3

Mentioned: 20 Post(s)
Tagged: 0 Thread(s)
Quoted: 1795 Post(s)
Liked 1,269 Times in 876 Posts
I had one once on an old 10 speed. I had problem with the Master Link.
The pin seem just a bit too short, and the clip didn't secure it well enough.
I'd usually catch it in time, but once I didn't and the chain separated, ripping the Fder into a pretzel.
IF I had a chain tool at the time, I could have just removed the Master link when I shortened the chain and it would have been fine.
So my caveat is make sure the Master Link closes securely!
A local "sporting goods & more" store carries the KMC Z51 for $6, so that's what I buy now. I just expect to put on a new one each Spring for that price.
Bill Kapaun is offline  
Old 12-09-07, 04:22 PM
  #14  
Been Around Awhile
 
I-Like-To-Bike's Avatar
 
Join Date: Oct 2004
Location: Burlington Iowa
Posts: 29,973

Bikes: Vaterland and Ragazzi

Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Quoted: 12 Post(s)
Liked 1,536 Times in 1,045 Posts
Originally Posted by dobber
They do indeed work well. I wouldn't do any extended trips on them without backup, but then again I wouldn't do that with any chain.
Do you actually carry a "backup" chain on extended trips? My backup would be to carry $5-10 to buy another chain at the nearest Xmart or LBS in the unlikely event that one failed while riding. My Track record: zero chain failures in over 50 years of cycling. I currently use Bell Chains without any problems.
I-Like-To-Bike is offline  

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are Off
Pingbacks are Off
Refbacks are Off



Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.