Bike Forums

Bike Forums (https://www.bikeforums.net/forum.php)
-   General Cycling Discussion (https://www.bikeforums.net/general-cycling-discussion/)
-   -   Repainting a New Bike (https://www.bikeforums.net/general-cycling-discussion/543370-repainting-new-bike.html)

abstractform20 05-19-09 08:53 PM

Repainting a New Bike
 
i have a new folding bike that i want to repaint.

this is my bike...any advice or tips?

i want it to be emerald green. would a can of krylon spray paint for metal be fine?

do i need to sand and primer it , etc???

thanks for the helpl!

http://i7.photobucket.com/albums/y29...1/IMG_1665.jpg

GTALuigi 05-19-09 09:51 PM

hmmm... interesting you should ask, since i was about to do the same to also my folding bike.
it came in commando green, i want it on any other colour but green.
LOL :D

abstractform20 05-19-09 10:12 PM

funny you dont want green, as i am looking to paint it emerald green...touche'

Velo Dog 05-19-09 10:36 PM

I've repainted half a dozen bikes i rebuilt for a local kids' club, so I can give a little advice.
First, whatever finish you apply at home will be less durable and scratch resistant than the factory paint. No way around it. It will look good initially, but bumps and bruises the factory paint would shrug off will leave marks.
A rattle can will do a decent job, with the caveat above. As with all paint jobs, preparation is 90 percent of the deal. You don't need to go down to bare metal (probably shouldn't, in fact, because the factory primer is better than you can do at home), but ALL grease, oil and wax has to be removed, and scuffing the paint with about 200 grit sandpaper will provide "tooth" for the new stuff.
Think about decals and stickers. Their outlines will show through the new paint unless they were clearcoated initially, and maybe even then.
It's best to strip the bike (of parts, not paint) to avoid overspray. Masking is another job that takes a lot of time (I've read that pros who paint custom bikes plan at least 10 minutes to mask each lug), but pays off with a clean, crisp-looking job. Buy good masking tape, preferably Frog Tape, not the junk at Home Depot. Then apply the paint in several light coats rather than one heavy one, sanding lightly between coats. It will look great until you ride it....

abstractform20 05-19-09 10:45 PM

how long can i expect my DIY to look reasonable and not ugly

Retro Grouch 05-20-09 08:22 PM


Originally Posted by abstractform20 (Post 8950052)
how long can i expect my DIY to look reasonable and not ugly

I've got a bike with at least 5 or 6 years on rattle can paint job. It has only a few top tube knicks.

I'm going to disagree with the other poster, however. I think that the key to getting a durable rattle can paint job is stripping the frame down to bare metal.


All times are GMT -6. The time now is 11:29 PM.


Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.