Marzocchi MZ Race 100mm
#1
Fourth Degree Legend
Thread Starter
Join Date: Jun 2005
Location: American Gardens Building
Posts: 3,826
Bikes: 2005 Kona Cinder Cone & 2010 Cannondale SuperSix
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Quoted: 0 Post(s)
Likes: 0
Liked 0 Times
in
0 Posts
Marzocchi MZ Race 100mm
Does anybody know anything about adjusting a Marzocchi MZ Race fork? I bought a Kona Cinder Cone a while back and this is the stock fork. The LBS did not provide me with any owners manual and the Marzocchi website is tough to navigate. I have not found much information on it. Just curious on adjusting rebound and stuff. Thanks.
#2
Just give'er.
Join Date: Nov 2003
Location: SF Bay Area
Posts: 1,899
Bikes: 04 Scrap
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Quoted: 4 Post(s)
Likes: 0
Liked 0 Times
in
0 Posts
No rebound really, just the screws to stiffen and loosen. Take off the rubber caps of the fork (keep them) and if you tighten the screws, the suspension gets tighter and stiffer. If you loosen, the fork is softer.
#3
Junior Member
Join Date: Oct 2004
Posts: 16
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Quoted: 0 Post(s)
Likes: 0
Liked 0 Times
in
0 Posts
Here is the a link to the manual for your fork. It looks like the only adjustment I see for your fork is internal spring preload on page 27.
https://www.marzocchi.com/System/7962/2004-Taiwan-en.pdf
Hope this is what you are looking for.
https://www.marzocchi.com/System/7962/2004-Taiwan-en.pdf
Hope this is what you are looking for.
#4
Fourth Degree Legend
Thread Starter
Join Date: Jun 2005
Location: American Gardens Building
Posts: 3,826
Bikes: 2005 Kona Cinder Cone & 2010 Cannondale SuperSix
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Quoted: 0 Post(s)
Likes: 0
Liked 0 Times
in
0 Posts
Thank you both. Very helpful.