narrow bar
#1
Member
Thread Starter
Join Date: Jul 2005
Posts: 34
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Quoted: 0 Post(s)
Likes: 0
Liked 0 Times
in
0 Posts
narrow bar
any opinions on how narrow i can go on the handlbar on my xc rig? i need to cut them down but dont want to lose any control
#2
la vache fantôme
Join Date: Aug 2004
Location: NH
Posts: 6,266
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Quoted: 2 Post(s)
Likes: 0
Liked 1 Time
in
1 Post
Why do you need to cut them down? My handlebars are 22" across i think, with a 5deg bend. I would not go narrower than that
__________________
C://dos
C://dos.run
run.dos.run
C://dos
C://dos.run
run.dos.run
#3
UareFASTjustNOTfastENOUGH
Join Date: Jul 2005
Location: Amongst the hills in So.Cal.
Posts: 391
Bikes: Scott Gambler, Scott Ransom, Bianchi C2C 928
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Quoted: 0 Post(s)
Likes: 0
Liked 0 Times
in
0 Posts
Get a cheepo alloy bar and just keep removing material until you reach a point that is to short for your liking. Then cut your current bar to the length just above that. I know riders that look as if they are holding the stem and others such as my self with the longest possible bar.
#4
Throw the stick!!!!
My flat bar is 22.8" with a 5 degree bend. My bar ends take up about 1/2" on each side. That brings usable width to a little less than 22". No way I would want to go any narrower. That is just me though.
__________________
I may be fat but I'm slow enough to make up for it.