Bar end size vs handlebar size
#1
BBall junkie
Thread Starter
Join Date: Aug 2005
Location: Wichita, KS
Posts: 72
Bikes: Trek 4300
Mentioned: 1 Post(s)
Tagged: 0 Thread(s)
Quoted: 0 Post(s)
Likes: 0
Liked 0 Times
in
0 Posts
Bar end size vs handlebar size
I ordered an inexpensive set of bar ends from one of the online stores. When I received them I thought that the hole where they fit over the handlebar end seemed a little small.
So I checked the (minimal) packaging and found that they were 23.8mm. I didn't recall that being the dimension of my bars so I checked and they are 25.4mm.
I never even considered that there might be different sizes. I rechecked and there wasn't any information available from where I purchased the ends.
Is there any chance these ends will fit? The difference of 1.6mm in diameter seems minimal. I haven't taken off my grips because I don't want to foul them all up if the ends don't fit.
So I checked the (minimal) packaging and found that they were 23.8mm. I didn't recall that being the dimension of my bars so I checked and they are 25.4mm.
I never even considered that there might be different sizes. I rechecked and there wasn't any information available from where I purchased the ends.
Is there any chance these ends will fit? The difference of 1.6mm in diameter seems minimal. I haven't taken off my grips because I don't want to foul them all up if the ends don't fit.