Bought a bike, first ride=flat tire.
#1
Junior Member
Thread Starter
Join Date: Apr 2010
Posts: 24
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Quoted: 0 Post(s)
Likes: 0
Liked 0 Times
in
0 Posts
Bought a bike, first ride=flat tire.
Should I take it back and throw it at the store and demand they fix it or just stfu and get to fixing it myself?
500$ bike, rode it on a paved surface over nothing pointy. I had it one day and got the flat.
500$ bike, rode it on a paved surface over nothing pointy. I had it one day and got the flat.
#2
Frozen in carbonite
Join Date: Oct 2004
Location: Ottawa
Posts: 805
Bikes: '85 Full Cycle Cycle.
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Quoted: 0 Post(s)
Likes: 0
Liked 0 Times
in
0 Posts
Sometimes it's just bad luck. I would go back to the store, explain your story (don't be a dick about it) and they might fix it for free for you. Worst case scenario, you buy the new tube and have them figure out what caused it.
#3
Senior Member
Join Date: Aug 2008
Location: San Francisco
Posts: 1,332
Bikes: 1989 Team Miyata, 1989 Miyata 1400, 1989 Miyata 1400, 1986 Miyata 610, 2007 Specialized Stumpjumper Hardtail
Mentioned: 3 Post(s)
Tagged: 0 Thread(s)
Quoted: 16 Post(s)
Likes: 0
Liked 0 Times
in
0 Posts
STFU and fix it yourself. Flats happen on bikes.
#4
Junior Member
Thread Starter
Join Date: Apr 2010
Posts: 24
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Quoted: 0 Post(s)
Likes: 0
Liked 0 Times
in
0 Posts
Yeah, that's what I'm planning on doing. My post sounded pretty belligerent, and I apologize for that. I was hoping for a reply telling me whether it's covered under the warranty as it was only ridden once. I just didn't want to bring it to them and have them tell me it's up to me to fix when it should be covered.
#5
Junior Member
Thread Starter
Join Date: Apr 2010
Posts: 24
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Quoted: 0 Post(s)
Likes: 0
Liked 0 Times
in
0 Posts
Am I correct in assuming (I'm new to riding) that to prevent this again I'd need:
Another tube to swap out when the flat happens
The rimming tool
A frame mounted pump or single-use inflator
Patching equipment to repair the tubes as I swap them out
And generally store them in the under-the-seat bag?
Also, do they sell the adapters for the presta valves anywhere common like MC sports or Dunham'?
I'm headed back to get the stuff today, the 10 mile walk home last night after the flat wasn't bad as the weather was perfect but I'd prefer not to get caught again when I'm time constrained as I ride to work.
Another tube to swap out when the flat happens
The rimming tool
A frame mounted pump or single-use inflator
Patching equipment to repair the tubes as I swap them out
And generally store them in the under-the-seat bag?
Also, do they sell the adapters for the presta valves anywhere common like MC sports or Dunham'?
I'm headed back to get the stuff today, the 10 mile walk home last night after the flat wasn't bad as the weather was perfect but I'd prefer not to get caught again when I'm time constrained as I ride to work.
Last edited by Mile21; 05-31-11 at 09:04 AM. Reason: Added valve question
#6
mechanically sound
Flat tires are generally not covered, being that they are so common. If you don't know how to change the tube, bring it back to the shop and politely ask for a tube-changing lesson after buying a new tube. They just might have pity and throw you a tube no charge.
__________________
#7
Junior Member
Thread Starter
Join Date: Apr 2010
Posts: 24
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Quoted: 0 Post(s)
Likes: 0
Liked 0 Times
in
0 Posts
Took the tire off in search of the cause of the flat and found the presta valve nut was loose. Can this be the cause of the flat or would it only loose air if pressed down?
#8
Senior Member
Join Date: Jan 2010
Posts: 219
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Quoted: 0 Post(s)
Liked 0 Times
in
0 Posts
in your general assortment of items to carry about with you while riding keep a tube repair kit like the 'Park Tools Tire and Tube repair kit (TR-1)'. Comes with adhesive backed patches, a small square of emory cloth to scuff up the area to be patched and tire levers. Very small kit, very important kit and will save you from walking her back more than a few times. As small a pump as you can get away with, minipumps are not as good as a good old fashioned full sized t-handled pump (get one of those for home, I have one at home and keep another in the trunk of my car) but a minipump is generally small enough to toss in your pack and will ensure that you have a pump handy when needed. Works well, but tend to give you a bit of a workout BUT when needed and you our out in the wilderness it is a godsend.
Flats happen! For some folks more frequently than others. Unless the tube was not installed properly (pinch flat because of tube not seated properly) I fail to see how this is your shops fault.
Some folks carry an extra tire in their backpacks (catastrophic tire damage is rare but does happen...sharp rock rips your sidewall for example), depending on the type of bike/riding you do it might make sense to toss a folding bead tire in your pack (only if it makes sense for your situation of course.). Consider also a spare tube. Of course the other obvious avenue would be to seek out tires that are better at resisting punctures, thicker tubes (thorn-resistanct for example) and/or "slime" to assist in managing punctures. All a balance act and simply depends of how much redundancy makes sense for your situation...The ultimate I suppose will be to go 'tubeless' and use stans no-tube solution. Lots of mountainbikers do this and swear by it. It will likely mean you have to first find the tire/wheel combination that is ideal. Check out vid! https://youtu.be/FTlZvOVG8zs. Going with a 'Stans' solution pretty much means no flats ever again (tears could happen tho) and generally is the 'ultimate' solution out there.
I dont think the loose presta valve nut would cause it unless you had sharp edges or burrs on the stem hole of your wheel. Is that where the puncture occured? If so it would obviously be the cause and I would then talk nicely with the folks at your LBS.
Either way, when repairing a flat be sure to run you hand around the entire inner circumference of the tire to make sure you locate and account for whatever caused the puncture. If not you might find yourself repairing a puncture only to mount the tube and subject it the the very same object (thorn head that pierced thru the sidewall for example) that caused the puncture. Feel about and look to ensure there is nothing in there to cause any bother.
Always carry a repair kit and a pump of some sort, debris and object sharp enough to cause bother are an unfortunate fact while riding on the trails and it sucks to be miles along only to have some otherwise easy to repair flat force to you to have to walk all the way back to the trailhead/car..total pain.
Once you know how, repairing a standard flat wont take but three or four minutes, often a tad faster if you quit screwing around and take the wheel off the bike (I have to tell myself this at times...always goes faster if I just take the darn wheel off).
Flats happen! For some folks more frequently than others. Unless the tube was not installed properly (pinch flat because of tube not seated properly) I fail to see how this is your shops fault.
Some folks carry an extra tire in their backpacks (catastrophic tire damage is rare but does happen...sharp rock rips your sidewall for example), depending on the type of bike/riding you do it might make sense to toss a folding bead tire in your pack (only if it makes sense for your situation of course.). Consider also a spare tube. Of course the other obvious avenue would be to seek out tires that are better at resisting punctures, thicker tubes (thorn-resistanct for example) and/or "slime" to assist in managing punctures. All a balance act and simply depends of how much redundancy makes sense for your situation...The ultimate I suppose will be to go 'tubeless' and use stans no-tube solution. Lots of mountainbikers do this and swear by it. It will likely mean you have to first find the tire/wheel combination that is ideal. Check out vid! https://youtu.be/FTlZvOVG8zs. Going with a 'Stans' solution pretty much means no flats ever again (tears could happen tho) and generally is the 'ultimate' solution out there.
I dont think the loose presta valve nut would cause it unless you had sharp edges or burrs on the stem hole of your wheel. Is that where the puncture occured? If so it would obviously be the cause and I would then talk nicely with the folks at your LBS.
Either way, when repairing a flat be sure to run you hand around the entire inner circumference of the tire to make sure you locate and account for whatever caused the puncture. If not you might find yourself repairing a puncture only to mount the tube and subject it the the very same object (thorn head that pierced thru the sidewall for example) that caused the puncture. Feel about and look to ensure there is nothing in there to cause any bother.
Always carry a repair kit and a pump of some sort, debris and object sharp enough to cause bother are an unfortunate fact while riding on the trails and it sucks to be miles along only to have some otherwise easy to repair flat force to you to have to walk all the way back to the trailhead/car..total pain.
Once you know how, repairing a standard flat wont take but three or four minutes, often a tad faster if you quit screwing around and take the wheel off the bike (I have to tell myself this at times...always goes faster if I just take the darn wheel off).
Last edited by Moozh; 05-31-11 at 10:25 AM.
#9
2 Fat 2 Furious
Join Date: Nov 2010
Location: England
Posts: 3,996
Bikes: 2009 Specialized Rockhopper Comp Disc, 2009 Specialized Tricross Sport RIP
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Quoted: 6 Post(s)
Likes: 0
Liked 2 Times
in
1 Post
As someone already said if you take it back and politely ask them to show you how to change the tube then (assuming they aren't busy) I'd hope they would. They might even throw in the tube as a goodwill gesture. Just don't go thinking you've got any entitlement to a free tube unless they sold you a bike with a specific defect that caused the flat.
If you find yourself getting a lot of punctures you might want to look at changing your tyres to something more puncture resistant. I've put something like 3000 miles on my Schwalbe Marathon Plus tyre and nothing has gone through it. A couple of times I've pulled inch-long thorns out of the rubber, and they haven't pierced the plasting armouring.
#10
2 Fat 2 Furious
Join Date: Nov 2010
Location: England
Posts: 3,996
Bikes: 2009 Specialized Rockhopper Comp Disc, 2009 Specialized Tricross Sport RIP
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Quoted: 6 Post(s)
Likes: 0
Liked 2 Times
in
1 Post
Either way, when repairing a flat be sure to run you hand around the entire inner circumference of the tire to make sure you locate and account for whatever caused the puncture. If not you might find yourself repairing a puncture only to mount the tube and subject it the the very same object (thorn head that pierced thru the sidewall for example) that caused the puncture. Feel about and look to ensure there is nothing in there to cause any bother.
He was seriously unlucky to have that happen, but it can happen.
#11
Senior Member
Join Date: Feb 2011
Location: Garden City South Carolina
Posts: 154
Bikes: Colnago Master. Cannondale caad4
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Quoted: 0 Post(s)
Likes: 0
Liked 0 Times
in
0 Posts
you might want to think about some nice kevlar belted tires
#12
Junior Member
Thread Starter
Join Date: Apr 2010
Posts: 24
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Quoted: 0 Post(s)
Likes: 0
Liked 0 Times
in
0 Posts
Good news! I took the tube out, submerged it, and couldn't find a leak. So I loosened the presta valve nut and put the dust cap on and submerged that and found it was leaking quite profusely. So I've to just pick up a pump today and the patching accessories Moozh posted and I should be good! Thanks for the help guys!
#13
Pint-Sized Gnar Shredder
Join Date: Nov 2007
Location: Somewhere between heaven and hell
Posts: 3,549
Bikes: '09 Jamis Komodo, '09 Mirraco Blend One, '08 Cervelo P2C, '08 Specialized Ruby Elite, '07 Yeti AS-R SL, '07 DMR Drone
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Quoted: 0 Post(s)
Likes: 0
Liked 0 Times
in
0 Posts
One more thing just because you pointed out the price of the bike. That ain't it. It's got more to do with where you ride and what kind of tires you have on there. I lose track of how many flats I get on my $3500 bike with weenie tires that get ridden wherever. On the other hand, I think I've changed one flat on my cheap-o DMR that sees asphalt and packed dirt and doesn't have light tires.
#14
Junior Member
Thread Starter
Join Date: Apr 2010
Posts: 24
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Quoted: 0 Post(s)
Likes: 0
Liked 0 Times
in
0 Posts
Yeah I still haven't had a flat on my road bike that I put 1100 miles on last Summer, and it cost a whopping 150$. Thanks for the input everyone
#15
Senior Member
Join Date: Feb 2011
Location: Garden City South Carolina
Posts: 154
Bikes: Colnago Master. Cannondale caad4
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Quoted: 0 Post(s)
Likes: 0
Liked 0 Times
in
0 Posts
i had a earing in a tire once (better than the whole ear)