Frame Pump Mount?
 

I have a topeak road morph that mounts to the water bottle location on my frame. I would rather not give up a cage for the pump but I have seen pumps mounted to run along side the cage. Anybody know where to buy these mounts?

put the pump in your jersey pocket.

the road morph is really long. At least with my jerseys its never felt secure.

Um, I don't know that one specifically, but usually you put the pump mount on, and then the water bottle cage on top of it.

Edit: nevermind, I found some pictures and it doesn't look like it goes to the side. That's lame.

get a lezyne then, they're better.

http://performancebike.com/images/pe...97-NCL-TOP.JPG

Ther have been other threads where people say this mount works. I haven't tried it but it's only $1.49 so it might be worth the gamble.

http://www.performancebike.com/bikes..._400007_400168

+a bazillion

That's the one I use. I put a two rings of electrical tape wrappings around my RoadMorph to get the diameter up. It now holds securely with the velcro closure. Works like a charm.

That's the one I use. I put a two rings of electrical tape wrappings around my RoadMorph to get the diameter up. It now holds securely with the velcro closure. Works like a charm.

You can purchase the mount you want direct from Topeak, I did ----- bout $4.95 delivered. Lp

Same, except I super glued some pieces of old tube into the mount to make a tight fit instead of putting anything on the pump itself.

thanks for the info. the perfomance one is out of stock, so i'll be going for the topeak one.

My road morph came with longer cage bolts so that the cage can be mounted on top of the holder for the pump and still be able to reach the holes to screw in securely. However, I need a narrow q-factor so I bound the pump with the mount to the underside of my top tube instead.

Co2

I used that hurricane one for a while until it snapped off. Funny story: I was bored so I asked style-man (when he was still at Bicycling (I get it for free)) if it was okay to do so because I wrapped duct tape around the pump to make it fit. Made it into the November 08 issue.

I now use the bracket that came with it and mount it on the underside if the downtube with the zipties that came with it.

Full size pump under the top tube, if your frame geometry works for that.