How to adjust saddle angle
 

I have a Specialized Allez I bought a few months ago. In my quest to get the fit right I need to tilt the nose of my saddle up a bit(it is almost level to possibly down sloping a bit). I have looked at this thing from 20 different angles and can not figure out how to tilt it up.

There are 2 bolts, one I have access to the head of from the bottom, but all this one does is tension the bracket for forward and aft movement. The other bolt, the head is hidden by the saddle itself. It has a knurled head on it, but when I grab it with some pliers, all it does is spin and does not allow the actual bolt to turn and I cant get access to the top of the bolt head to get an allen wrench on it. Anybody have any ideas? Do I need to completely remove the saddle from the seat post in order to adjust the angle?

You should be able to:

1) Loosen the rear bolt with an allen key
2) Turn the knurled knob at the front to raise or lower the nose of the seat
3) Tighten down the rear bolt to fine tune the levelling - but make sure its tight ENOUGH to prevent fore and aft sliding of the seat.

If you've already reefed on the knurled knob with pliers without loosing the rear, and now its spinning freely from the bolt, you need a new front bolt/knob assembly - you've stripped it.

I think I already tried this and the front wouldnt move. Ill give it another shot. Worst comes to worst I will grab a new front bolt and throw it in. Not the first time, nor will it be the last time I destroyed something and have to replace a bolt(or 3 or 4).