Problem with Hudz fit
01-14-12, 01:25 PM
#1
Senior Member
Thread Starter
Join Date: Mar 2007
Posts: 393
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Quoted: 3 Post(s)
Likes: 0
Liked 1 Time
in
1 Post
Problem with Hudz fit
I purchased a set of Hudz replacement brake hoods to install on a SRAM Rival equipped bike and am having a problem with the left hand side lever. The right side hood fits perfectly, but the left hand side ends up having a gap (about 1/4") right on the front of the lever body when the hood button is in the corresponding hole on the lever. I've tried stretching the hood to make up the gap, which only results in the button popping out and the fit being completely wrong. I've tried emailing Hudz but am not having much luck getting a response so I thought I would check here and see if this is common problem with Hudz or if I simply got a defective hood and am plain SOL (since Hudz won't answer my emails). Thank you in advance for any help.
