Bike Forums

Go Back  Bike Forums > Search Forums
Reload this Page >

Search Results

Register
FAQ
Calendar
Today's Posts
Search
Vendor Directory
Notices
Search: Posts Made By: CGoose
Showing results 1 to 8 of 8
Search took 0.01 seconds.
Forum: Mountain Biking
10-06-08, 03:39 PM
Replies: 2
Views: 465
Posted By CGoose

If I were in your shoes, I'd likely go with the...

If I were in your shoes, I'd likely go with the LX and then take the time to take it apart and properly adjust it before running it. I've seen the lock nuts on the drive side of many Shimano hubs...
Forum: Mountain Biking
10-06-08, 03:35 PM
Replies: 10
Views: 572
Posted By CGoose

Also, most measurements are taken center to...

Also, most measurements are taken center to center, or center to top. In other words, the Seat tube length would be measured from the center of the Bottom Bracket (the spindle the cranks rotate on)...
Forum: Bicycle Mechanics
10-06-08, 02:41 PM
Replies: 6
Views: 2,323
Posted By CGoose

If for some reason you end up with upper pulley...

If for some reason you end up with upper pulley wheel rub on the 34T while you're shifting in and out of it, tighten your B-tension screw. If it's already maxed out, remove the derailleur, remove the...
Forum: Mountain Biking
10-06-08, 02:35 PM
Replies: 11
Views: 494
Posted By CGoose

The best way I've found to see if it's one of the...

The best way I've found to see if it's one of the "good ones" as far as recent Marzocchi goes is to look at where it's made. If it says "made in Italy" you'll likely be pretty happy with it. If it...
Forum: Mountain Biking
10-06-08, 11:36 AM
Replies: 25
Views: 7,384
Posted By CGoose

You can pick stuff up on great deals, but as far...

You can pick stuff up on great deals, but as far as looking at retail prices go, I'd just have to advise getting used to it. Honestly, what you get for $300 these days is FAR better than what you'd...
Forum: Mountain Biking
10-06-08, 10:18 AM
Replies: 7
Views: 2,617
Posted By CGoose

Don't know if you did anything already, but just...

Don't know if you did anything already, but just thought I'd give you a little info. It's no problem to put a spacer in there. Marzoccchi actually uses a small plastic PVC like spacer on the top of...
Forum: Mountain Biking
09-28-08, 09:22 PM
Replies: 8
Views: 838
Posted By CGoose

If I were in your spot I'd keep the Bonty simply...

If I were in your spot I'd keep the Bonty simply because it's a Bonty and sell the Marin. They're both nice frames though, so I don't think you could go wrong with either. Like TheFlip said... keep...
Forum: Mountain Biking
09-28-08, 06:50 PM
Replies: 7
Views: 2,617
Posted By CGoose

I would go with the Junior T. I have no doubt...

I would go with the Junior T. I have no doubt someone will correct me if I'm wrong about any of this, but here is why...
The dropoffs were made by SR Suntour in their factory in Taiwan. The...
Showing results 1 to 8 of 8


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.