Search: Posts Made By: Dan333SP
Showing results 1 to 9 of 9
Search took 0.02 seconds.
Forum: Road Cycling
07-08-19, 12:18 PM
Replies: 47
Views: 2,084
Posted By Dan333SP

The answer to this thread is Doge's kid :)

The answer to this thread is Doge's kid :)
Forum: Road Cycling
07-08-19, 11:40 AM
Replies: 32
Views: 1,261
Posted By Dan333SP

If it's a gradual incline with kickers in the...

If it's a gradual incline with kickers in the middle (say, 4-5% with short bits over 10%), I'll go anaerobic on the short pitches and recover on the more gradual stretch that follows.
Forum: Road Cycling
07-07-19, 04:34 PM
Replies: 47
Views: 2,084
Posted By Dan333SP

What you're really looking for is a continuation...

What you're really looking for is a continuation of the "Merckx rules" hour record, where people would run basically the same equipment Eddy used in 1972. Those rules were abandoned in 2014 in favor...
Forum: Road Cycling
06-26-19, 09:20 AM
Replies: 14
Views: 993
Posted By Dan333SP

I had the most annoying creak recently that was...

I had the most annoying creak recently that was similar to the OP's. Was convinced it was my headset bearings so I took them out and cleaned/regreased them multiple times without success. Turns out...
Forum: Road Cycling
06-18-19, 01:57 PM
Replies: 27
Views: 1,783
Posted By Dan333SP

ASSOS makes BIG $ kit. That's my only input here.

ASSOS makes BIG $ kit. That's my only input here.
Forum: Road Cycling
06-14-19, 08:17 AM
Replies: 129
Views: 8,979
Posted By Dan333SP

What if one of his valve caps was that valve cap...

What if one of his valve caps was that valve cap power meter that is 100.3% accurate? Just knowing your power can make you 2-3 mph faster.
Forum: Road Cycling
06-05-19, 10:45 AM
Replies: 129
Views: 8,979
Posted By Dan333SP

What cable housings are you running? That can...

What cable housings are you running? That can make a big difference.
Forum: Road Cycling
05-30-19, 03:55 PM
Replies: 16
Views: 879
Posted By Dan333SP

ProTip: When mounting new carbon bars, make sure...

ProTip: When mounting new carbon bars, make sure to torque down with the stem faceplate bolts until you hear some light but audible cracking, then back off a quarter turn with each bolt.
Forum: Road Cycling
05-30-19, 01:35 PM
Replies: 77
Views: 8,170
Posted By Dan333SP

The actual tire bead removal and tube change from...

The actual tire bead removal and tube change from start to finish probably takes me under 2 minutes. It's the 5-10 minutes I spend pulling the tire off the rim entirely and inspecting for whatever...
Showing results 1 to 9 of 9


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service

Copyright 2018 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.