Search: Posts Made By: Metaluna
Showing results 1 to 9 of 9
Search took 0.01 seconds.
07-15-19, 08:28 PM
Replies: 5
Views: 127
Posted By Metaluna

If possible, look into using lower gearing and...

If possible, look into using lower gearing and spinning up the hills more. This should result in torquing the rear end less, so less flexing, therefore less ghost shifting, rear brake rotor rubbing,...
07-03-19, 10:48 AM
Replies: 6
Views: 416
Posted By Metaluna

Before you start diving into e-Tube, I think we...

Before you start diving into e-Tube, I think we need more information on how you shift. There are a lot of different ways to shift in Di2, and the "shift mode" you're in heavily influences both how...
07-02-19, 03:29 PM
Replies: 21
Views: 599
Posted By Metaluna

Those are 10sp road shifters. They won't pull...

Those are 10sp road shifters. They won't pull enough cable for a 10sp MTB (aka Dyna-Sys) rear derailleur.
06-28-19, 01:06 PM
Replies: 16
Views: 537
Posted By Metaluna

I'm 99% sure that what you have there are...

I'm 99% sure that what you have there are standard Shimano B01S-compatible pads. Tektro/TRP is well-known to use Shimano B01S clones on a wide range of their brakes, so you don't have to go crazy...
06-19-19, 10:18 AM
Replies: 28
Views: 1,524
Posted By Metaluna

“Ruin the bearings” is way too strong of a...

“Ruin the bearings” is way too strong of a description IMHO. If you have the preload too tight, it will subject the bearings to elevated wear, meaning your bottom bracket won’t last quite as long...
06-12-19, 10:33 AM
Replies: 11
Views: 558
Posted By Metaluna

No the width is only half the information you...

No the width is only half the information you need for matching the hub axle. There are two "worlds" when it comes to modern hubs -- those with quick release axles and those with through axles. Quick...
06-10-19, 06:30 AM
Replies: 9
Views: 761
Posted By Metaluna

To be fair, they probably can point to tests...

To be fair, they probably can point to tests where they had some pro cyclist doing 1500 watt sprints and found that front shifts were 0.15 seconds slower at some specific gear combination. ...
05-30-19, 03:12 PM
Replies: 6
Views: 446
Posted By Metaluna

So if I understand this correctly, you want to...

So if I understand this correctly, you want to use an Alfine Hollowtech II crank (FC-S501?). That component is designed for a 68mm bottom bracket shell.

(See the following link, scroll down to...
05-16-19, 04:17 PM
Replies: 21
Views: 735
Posted By Metaluna

*Some* Shimano 9 and 10 speed drivetrain...

*Some* Shimano 9 and 10 speed drivetrain components are interchangeable within limits (e.g. rear derailleurs). Unfortunately chains are not on that list, at least not reliably. A 9sp chain is almost...
Showing results 1 to 9 of 9


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service

Copyright 2018 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.