Go Back  Bike Forums > Search Forums
Reload this Page >

Search Results

Notices
Search: Posts Made By: mitchmellow62
Showing results 1 to 11 of 11
Search took 0.01 seconds.
01-03-21, 03:03 PM
Replies: 20
Views: 779
Posted By Crankycrank

Looks like you have enough clearance to me but...

Looks like you have enough clearance to me but yes, a road test is needed to be sure.
10-23-20, 08:14 AM
Replies: 17
Views: 880
Posted By Trakhak

I'd begin by determining whether the problem is...

I'd begin by determining whether the problem is in the bottom bracket or elsewhere.

Drop the chain off the chainring. If the problem goes away, investigate the rear hub next.

If the problem...
08-21-20, 05:56 AM
Replies: 20
Views: 1,099
Posted By Pop N Wood

Man, so many judgmental people in this world...

Man, so many judgmental people in this world anymore. Free thinking is being beat into submission. did you at least wear a mask, helmet and eye protection when you did it?

BTW I agree looks like...
08-01-20, 06:53 PM
Replies: 7
Views: 996
Posted By dsbrantjr

It cannot, the numbers do not add up. You would...

It cannot, the numbers do not add up. You would need less than 13 teeth difference up front not to exceed the 28t wrap capacity. You cannot necessarily have the max front difference AND the...
07-21-20, 05:18 PM
Replies: 7
Views: 555
Posted By dsbrantjr

I would suggest you consider Ergon grips; I have...

I would suggest you consider Ergon grips; I have had good success with them. I use the GP1 Biokork ones, but some of the others have extensions which provide alternate hand positions which might be...
06-04-20, 01:20 PM
Replies: 30
Views: 1,314
Posted By HTupolev

Unless you both ride similar terrain as the OP...

Unless you both ride similar terrain as the OP and have very similar physical ability, what works for you doesn't have much to do with what will work for them. Even relatively small differences in...
05-29-20, 06:37 AM
Replies: 18
Views: 1,330
Posted By rccardr

That should be a 26.4 clamp on a 26.4 bar. ...

That should be a 26.4 clamp on a 26.4 bar. Measure to make sure. If it's a 26mm bar, no amount of tightening will actually make that combination safe, at any angle.
If the sizing matches,...
01-18-20, 09:47 AM
Replies: 16
Views: 1,293
Posted By _ForceD_

I don't like exposed adhesive tape at all. I wrap...

I don't like exposed adhesive tape at all. I wrap from the top down and secure the end inside the handlebar with the plug. No exposed, unsightly tape. Some people say that wrapping this opposite way...
11-27-19, 05:21 PM
Replies: 5
Views: 296
Posted By canklecat

I like a road setup for my road bikes for a few...

I like a road setup for my road bikes for a few reasons:

I prefer really stiff soles for arch support. I've always had foot problems, including burning arch cramps from inadequate foot support....
11-18-19, 12:10 PM
Replies: 53
Views: 4,345
Posted By philbob57

For me, the only solution would be to lose 35-40...

For me, the only solution would be to lose 35-40 years. When I was 35-40, all I needed for 32 degree rides was jean for the legs, and winter gloves and my normal winter parka for my trunk. (Sorry -...
10-10-19, 09:24 AM
Replies: 68
Views: 7,243
Posted By well biked

To the OP, I quickly checked the specs on your...

To the OP, I quickly checked the specs on your Giant ATX 3, it uses a very inexpensive chain ("8 speed chain").

Whatever you do regarding chain lube/chain cleaning, just remember the chain itself...
Showing results 1 to 11 of 11


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service - Do Not Sell My Personal Information -

Copyright 2021 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.