Zipp 182 Track Axle
#28
Newbie
Join Date: Nov 2022
Posts: 1
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Quoted: 0 Post(s)
Likes: 0
Liked 0 Times
in
0 Posts
rustymongrel Have emailed you. Will wait to hear back. Cheers
#29
Newbie
Join Date: Dec 2022
Posts: 2
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Quoted: 1 Post(s)
Likes: 0
Liked 0 Times
in
0 Posts
Hi rustymongrel, I just found this thread lately. By any chance would you still have this axle kit, or could make more?
I sent you a e-mail as well. Thank you very much.
Regards,
Henry
I sent you a e-mail as well. Thank you very much.
Regards,
Henry
#30
Newbie
Join Date: Dec 2022
Posts: 2
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Quoted: 1 Post(s)
Likes: 0
Liked 0 Times
in
0 Posts
Hello,
For those adapting a Miche axle to the Zipp 900, the Miche bearing "cups" have 12mm OD, while the 182 hub bearings have 15mm bore. What do you use to take up the 3mm difference?
For those adapting a Miche axle to the Zipp 900, the Miche bearing "cups" have 12mm OD, while the 182 hub bearings have 15mm bore. What do you use to take up the 3mm difference?
#31
Junior Member
Thread Starter
Join Date: Jun 2010
Posts: 134
Mentioned: 1 Post(s)
Tagged: 0 Thread(s)
Quoted: 70 Post(s)
Likes: 0
Liked 5 Times
in
5 Posts
Heu sorry for the late response but you can swap the bearings for ones that are 12mm ID with the same OD as the Zipp bearings. Can’t recall the bearing number of the top of my head. The width is slightly different if I recall but doesn’t really affect anything.