Help the Old Man
#1
Newbie
Thread Starter
Join Date: Oct 2004
Posts: 3
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Quoted: 0 Post(s)
Likes: 0
Liked 0 Times
in
0 Posts
Help the Old Man
Greetings!
Last year I purchased a new Bianchi Pista. It came with the standard 48 size chainring (TruVativ Elita ISIS Drive) and 16T rear cog. Being over 50 years old and just getting started back into biking, the gearing is too tall for me. So therefore, I need to change the gearing. Is it easier to change the crank chain ring to a smaller gearing, or should I leave it and change the rear cog? You comments, thoughts, and opinions are greatly appreciated.
Last year I purchased a new Bianchi Pista. It came with the standard 48 size chainring (TruVativ Elita ISIS Drive) and 16T rear cog. Being over 50 years old and just getting started back into biking, the gearing is too tall for me. So therefore, I need to change the gearing. Is it easier to change the crank chain ring to a smaller gearing, or should I leave it and change the rear cog? You comments, thoughts, and opinions are greatly appreciated.
#2
Senior Member
Join Date: Nov 2004
Location: Irving, TX
Posts: 406
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Quoted: 0 Post(s)
Likes: 0
Liked 0 Times
in
0 Posts
Dont' worry, an 81 inch gear is too big for many youngsters as well. Personally I'd change the cog. A 20 tooth would give you a 64.8 inch gear. If you don't have a gear chart handy here's a link. https://home.i1.net/~dwolfe/gerz/
#3
Iguana Subsystem
Join Date: Nov 2004
Location: san francisco
Posts: 4,016
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Quoted: 0 Post(s)
Likes: 0
Liked 0 Times
in
0 Posts
you need fewer tools to change the front chainring; an allen wrench vs. a chainwhip and a lockring wrench.
you may also need a chain tool so you can shorten the chain.
you may also need a chain tool so you can shorten the chain.
#4
Senior Member
Join Date: Apr 2005
Location: Boston, MA
Posts: 787
Bikes: https://www.jacobsbicycles.com
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Quoted: 0 Post(s)
Likes: 0
Liked 0 Times
in
0 Posts
If you go to a shop, it shouldn't cost more than $30 for a new cog, and maybe $20 for labor if they're meanies, especially if it's the shop that sold you the bike.
#5
Patrick Barber
Join Date: Apr 2005
Location: Portland, Oregon
Posts: 888
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Quoted: 0 Post(s)
Likes: 0
Liked 0 Times
in
0 Posts
changing the chainring is easier to do yourself if you're short on tools. another good gear calculator is https://sheldonbrown.com/gears/
i'm pushin' 40 (years) and 65 (gear inches). recently decreased from 70 inches, and enjoying it very much.
i'm pushin' 40 (years) and 65 (gear inches). recently decreased from 70 inches, and enjoying it very much.