Miche Hub bearing size?
 

for rear high flange sealed track hub.

Anyone know what the I.D. O.D. and width is?

Or any other bearings that are compatible? Specifically model number.

thanks.

haven't seen you around in a while! what's up? anything new?

not much. Just don't have the passion for BF like i used to. Have a new bike though. And i bought some new wheels from Slopps.

I am 99% sure it is the 6001 standard. Any bearing house should have them. I would call Business Cycles just to be sure, thats what I did when I replaced the bearings in my Miche hubs.

thanks man, i see the standard 6001 is 12mm 28mm 8mm but i have no way to measure nor have i swapped em out before but a chart i found online had the same info for Miche. Slopps was saying that he thought Phil R8 was the right one, but it has different measurements. I'm going to roll by the local shop on the way home anyway.

ok. So the 6001 was the right one, just an fyi if anyone was interested.

After getting new bearings put in on both sides that **** still doesn't spin smooth. WTF?

Not crunchy like before feels like its dragging or something.

Some bearings always feel draggy off the bike when you're spinning them by hand, some break in over time.

ive never had a draggy wheel. ever. i cant imagine it being normal or good. Especially since the front wheel is smooth. Anyone else experience this?

maybe ill go back to the shop again tomorrow and see if they can fix it.

by the way, Hi jim-bob, it's been a while eh?

I haven't built my Miche up yet (still waiting on spokes), but this isn't good news =[