Are all lockrings 24 tpi?
I have alex solo rims. I just purchased a surly cog and a shimano lock ring for me fixie. The cog spun on fine and I tightened it. I trying putting on the lockring (threading CCW) and it goes in a couple of lines and then just stops. It appears stuck and I don't wanna force it because the rims are aluminum and I'm gonna strip the threads. Anysuggestions??
|
did you grease the lockring? check the threads for burrs or debris?
|
Originally Posted by elTwitcho
(Post 8170491)
did you grease the lockring? check the threads for burrs or debris?
THx!!! Found some crap where I wasn't looking. Cleaned the thread and it went in. Mucho appreciated.:) |
mavic ellipse hubs take special (french?) threaded lockrings...I managed to tighten a soma (english) lockring on one side of my ellipse wheel - it was hard. I have since removed it and use the other "good" side for now; not sure if I can use the other side now or not.
|
All times are GMT -6. The time now is 11:46 AM. |
Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.