|
Help: Width of the clamp area of a steel Nitto B123/125?
If someone has a set of steel Nitto B123s or B125s with a 25.4mm clamp that are off the bike, will you please measure the width of the clamp area in millimeters?
I'm thinking of getting a set, but I need to be sure that the clamp area of my stem will have enough to grip. Thanks |
carleton asking for help???
NOOO WAAAI |
haha to be honest it to me a sec to realize it and i was like what the??
|
|
http://i.imgur.com/Qu7oq.jpg
I'm just keepin' you guys on your toes.
Originally Posted by Scrodzilla
(Post 12488933)
|
thats a very narrow clamp width. id have guessed 40mm plus.
|
Originally Posted by adriano
(Post 12490280)
thats a very narrow clamp width. id have guessed 40mm plus.
Scrod, did you measure the L - R width? (not the diameter). |
Originally Posted by carleton
(Post 12491594)
Now that you mention it, that does seem narrow. That's just one inch.
Scrod, did you measure the L - R width? (not the diameter). |
Hahaha...I thought you meant you needed an accurate measurement of the diameter. I guess I'm even a little less "with it" than usual at 7 AM. If no one else steps up, I'll measure the width when I get back to our warehouse space tomorrow.
|
Thanks!
|
I estimate it to be 40mm.
|
Originally Posted by TejanoTrackie
(Post 12493587)
I estimate it to be 40mm.
|
42mm
|
Originally Posted by Scrodzilla
(Post 12494239)
42mm
Adriano and TT were dead-on. Those guys are smarter than they look! ;) |
|
| All times are GMT -6. The time now is 10:51 AM. |
Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.