Nitto Rb-018 + cross lever size question....
want to put the lever before the clamp area.
clamp area is 26mm...not sure what the bar diameter is. get a 26mm and shim or will the 24mm lever fit? |
24 will fit. However, if you put a 26mm on the bulge next to your stem, you won't lose as much of the top hand position on that side.
|
ideally that's what i wanted to do, but i have a thompson x4 stem and it interferes with the lever.
tested it with a paul cross lever, and it would not work. maybe it will work with a tektro or cane creek??? |
I can see how an X4 would be too wide and not allow enough clearance for the barrel adjuster on the lever. A 24mm clamp lever will fit where the bars taper down.
|
thanks, scrod.
722 is almost complete. |
Right on. Can't wait to see it!
|
All times are GMT -6. The time now is 04:30 AM. |
Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.