magnets in trainer duelling with computer?
#1
Newbie
Thread Starter
Join Date: Jan 2008
Location: portland or
Posts: 2
Bikes: lemond versailles for weekends and bianchi backstreet rigged up for commuting
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Quoted: 0 Post(s)
Likes: 0
Liked 0 Times
in
0 Posts
magnets in trainer duelling with computer?
I'm setting up my old trakstand Rx5 trainer with a bike and an older cycle computer so I can hopefully stay in shape while the weather is rotten. Thought using stuff I already have would be the cheap route, versus buying a stationary bike, when I'm not sure how much I'll use it. I moved the computer sensor and magnet to the back wheel, since the front wheel doesn't spin. Also, I swapped in fresh batteries in both the computer and the sensor. Moved the computer around so, while not convenient to me, it is as close to the sensor as it used to be on the front. Still, I don't get a reading. Then got this 'duh!!' thought that perhaps my trainer is magnetic, and it is interfering with the sensor? does anybody know if the Trakstand RX5 is magnetic, and if so, if the trainer's magnets would not be completely shielded, and if so, if this is most likely my problem? and don't laugh, any engineers out there!
#2
Senior Member
Join Date: Nov 2003
Location: Kanata, Ontario, Canada
Posts: 80
Bikes: Stevens SLC Road, Seven Ti SS MTB, Titus Ti FS-XC MTB, Empella Bonfire CX
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Quoted: 0 Post(s)
Likes: 0
Liked 0 Times
in
0 Posts
Up until a couple weeks ago (when I got my PowerTap), I was using a Sigma wireless computer [with the rear speed sensor moved from the front fork to rear seat stay (plus, moving the computer to the center of the TT instead of on the stem to get closer to the speed sensor)] and Tacx Satori trainer (magnetic) and I never had any issues in 2-months.
#3
You need a new bike
Join Date: Aug 2002
Posts: 5,433
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Quoted: 3 Post(s)
Likes: 0
Liked 4 Times
in
3 Posts
Remove the bike from the trainer and see if the computer works. If it doesn't, then you know the trainer is not the issue.
If the trainer is the problem, then get a cheap wired computer.
If the trainer is the problem, then get a cheap wired computer.